Ryobi HT816r Manuel d'utilisateur télécharger pdf (Page 10)

MAINTENANCE AND REPAIR INSTRUCTIONS

BLADE REPLACEMENT

WARNING: To avoid serious personal

injury, be sure the unit is off and unplugged

before cleaning or performing any

maintenance on it.

WARNING: When servicing, use only

identical Ryobi replacement parts. Use of

any other parts may create a hazard or cause

product damage.

WARNING: To prevent serious personal

injury, wear gloves when handling, removing

or installing the cutting blades. When

handling blade assembly, do not place your

hand or fingers between blades or in any

position where they could get pinched or cut.

Disconnect hedge trimmer from power supply.

1. Remove blade cover screw (Fig. 10).

2. Remove blade cover: To remove, push blade cover

forward and lift from hedge trimmer.

3. Remove blade screws (Fig. 11).

NOTE: A flat blade or # T20 Torx bit screwdriver. is

required to remove blade screws.

4. Remove grease cover and blade assembly.

5. Make sure drive washer remains installed on drive

pin (Fig. 11).

6. Align slot in new blade assembly and grease cover

with drive washer on gear assembly (Fig. 12).

7. After aligning, continue to hold blade assembly in

place, then manually slide blade assembly back and

forth until screw holes in grease cover align with

screw holes in gear housing (Fig. 13).

WARNING: Blades are sharp. When

manually sliding blade assembly, do not

place your hand or fingers between blades

or in any position where they could get

pinched or cut.

Fig. 10

Fig. 11

Drive Washer

Blade Screws

1 2 ... 5 6 7 8 9 10 11 12 13 14

Pas de commentaire

Ryobi HT816r Manuel d'utilisateur Page 10