Ryobi HT816r Manuel d'utilisateur télécharger pdf (Page 4)

RULES FOR SAFE OPERATION

BEFORE OPERATING

• Read the instructions carefully. Be familiar with the

controls and proper use of the unit.

• Children and teens under the age of 15 must not use

the unit, except for teens guided by an adult.

• Before each use, thoroughly inspect your unit for

loose or damaged parts. Do not use until adjustments

or repairs are made.

• All guards and safety attachments must be installed

properly before operating the unit.

• Use the unit only in daylight or good artificial light.

• Keep all bystanders, especially children and pets, at

least 50 feet (15 m) away from the unit while operating.

• To reduce the risk of electrical shock, this unit has a

polarized plug (one blade is wider than the other) and

will require the use of a polarized extension cord. This

unit plug will fit into a polarized extension cord only

one way. If the plug does not fit fully into the extension

cord, reverse the plug. If the plug still does not fit,

obtain a correct polarized extension cord. A polarized

extension cord will require the use of a polarized wall

outlet. This plug will fit into a polarized wall outlet only

one way. If the plug does not fit fully into the wall

outlet, reverse the plug. If the plug still does not fit,

contact a qualified electrician to install the proper wall

outlet. Do not change the unit plug, extension cord

receptacle, or extension cord plug in any way.

• Ground Fault Circuit Interrupter (GFCI) protection

should be provided on the circuit(s) or outlet(s) to be

used for this unit. Receptacles are available having

built-in GFCI protection and may be used for this

measure of safety.

• EXTENSION CORDS: Make sure your extension cord

is in good condition. When using an extension cord,

be sure to use a cord that is heavy enough to carry the

current that your unit will draw. An undersized

extension cord will cause a drop in line voltage

resulting in loss of power and overheating. The table

shows the correct size to use depending on the cord

length and nameplate amperage rating. If in doubt, use

the next heavier size line gauge. The smaller the gauge

number, the heavier the cord. To reduce the possibility

of disconnection of the unit from the extension cord

during operation, see Fig. 5, page 7.

• A nameplate on your unit indicates what voltage it

uses. Never connect the unit to an AC voltage that

differs from this voltage.

FOR SAFE OPERATION

• Avoid unintentional starting. Do not carry plugged-in

unit with your finger on the switch. Be sure switch is

off when plugging in.

• Always remain alert. Use common sense. To prevent

injury to yourself and others, do not operate this unit if

you are fatigued.

• Do not operate the unit while under the influence of

drugs, alcohol or medication.

• Wear safety glasses or goggles that are marked as

meeting ANSI Z87.1 standards, and ear/hearing

protection when operating this unit. Wear a face or

dust mask if the operation is dusty.

• Do not overreach or use the unit from unstable

surfaces such as ladders, trees, steep slopes,

rooftops, etc. Keep proper footing and balance at all

times.

• Wear heavy, long pants, boots, gloves and a long

sleeve shirt. Do not wear loose clothing, jewelry, short

pants, sandals or go barefoot. Secure hair above

shoulder level.

• Always stop the motor when cutting is delayed or

when walking from one cutting location to another.

• Keep unit clean of vegetation and other materials.

They may become lodged in the cutting blades.

• When operating the hedge trimmer, always hold the

unit with both hands. Keep a firm grip on both the

housing grip and front handle. Never grip the unit by

the guard or use the guard as a handle.

• Do not force unit. It will do the job better and with less

likelihood of injury at a rate for which it was designed.

• Use only genuine Ryobi replacement parts and

accessories for this unit. These are available from

your authorized service dealer. Use of any non Ryobi

parts or accessories could lead to serious injury to the

user, or damage to the unit, and void your warranty.

• This unit is provided with double-insulation. Use only

identical replacement parts. See instructions for

Servicing of Double-Insulated Units.

• If you strike or become entangled with a foreign

object, stop the unit immediately and check for

damage. Do not operate before repairing damage. Do

not operate the unit with loose or damaged parts.

• Maintain the unit with care. Keep cutting edge sharp

and clean for best performance and to reduce the risk

of injury. Follow instructions for lubricating and

changing accessories. Keep handles dry, clean and

free from oil and grease. Always use a clean cloth

when cleaning. Never use brake fluid, gasoline,

petroleum-based products, or any strong solvents to

clean your tool.

MINIMUM WIRE SIZE FOR EXTENSION CORDS

FOR 120 VOLT APPLIANCES

Cord length (ft) 25 50 100 150

Amperage Rating Wire size (AWG)

1 to 10 amps 18 16 14 12

10 to 12 amps 16 16 14 12

12 to 16 amps 14 12

NOT

RECOMMENDED

1 2 3 4 5 6 7 8 9 ... 13 14

Commentaires sur ces manuels

Pas de commentaire

Ryobi HT816r Manuel d'utilisateur Page 4

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel de jardinage Ryobi HT816r