Ryobi TSS120L Manuel d'utilisation et d'entretien télécharger pdf (Page 19)

19 − English

MITER

LOCK HANDLE

Fig. 20

MITER

TABLE

VIEW OF BLADE SQUARE WITH FENCE

SQUARE

BLADE

ASSEMBLY

REMOVING / REPLACING THE THROAT PLATE

See Figure 19.

WARNING:

The throat plate must be below the miter table. If the throat

plate is too high or too low, the workpiece can catch on

the uneven edges resulting in binding which could result

in serious personal injury.

Never operate the saw without a throat plate installed.

To remove / replace:

 Unplug the saw.

 Remove the screws securing the throat plate.

 Lift the throat plate from the saw.

 To reinstall the throat plate, align the holes in the throat

plate with the holes in the saw base.

 Retighten the screws, being careful not to overtighten

which can cause the throat plate to bow or bend.

ADJUSTING SUPPORT FOOT

See Figure 19.

Turn the support foot clockwise or counterclockwise

depending on the amount of support needed for making

sliding cuts.

NOTE: Many of the illustrations in this manual show only

portions of the compound miter saw. This is intentional so that

we can clearly show points being made in the illustrations.

Never operate the saw without all guards securely in

place and in good operating condition.

SQUARING THE BLADE TO THE FENCE

See Figures 20 - 26.

 Unplug the saw.

 Pull the saw arm all the way down and engage the lock

pin to hold the saw arm in transport position.

 Loosen the miter lock handle approximately one-half turn

and squeeze the detent release lever.

 Rotate the miter table until the scale indicator is positioned

at 0°.

 Release the detent release lever, and ensure the control

arm is seated in the positive notch.

 Tighten the miter lock knob to secure the miter table.

 Loosen bevel lock knob and set saw arm at 0° bevel

(blade set 90° to miter table). Tighten bevel lock knob.

 Lay a square flat on the miter table. Place one leg of the

square against the fence. Slide the other leg of the square

against the flat part of saw blade.

NOTE: Make sure that the square contacts the flat part

of the saw blade, not the blade teeth.

 The edge of the square and the saw blade should be

parallel as shown in figure 20.

THROAT

PLATE

Fig. 19

SUPPORT

FOOT

SLIDING

MITER

FENCE

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 103 104

Commentaires sur ces manuels

Pas de commentaire

Ryobi TSS120L Manuel d'utilisation et d'entretien Page 19

Commentaires sur ces manuels