Ryobi TSS120L Manuel d'utilisation et d'entretien télécharger pdf (Page 9)

9 − English

FEATURES

KNOW YOUR COMPOUND MITER SAW

See Figure 1.

The safe use of this product requires an understanding of

the information on the tool and in this operator’s manual as

well as a knowledge of the project you are attempting. Before

use of this product, familiarize yourself with all operating

features and safety rules.

12 in. BLADE

A 12 in. blade is included with the compound miter saw.

It will cut materials up to 3-1/2 in. thick or 13-1/2 in. wide,

depending upon the angle at which the cut is being made.

BASE/CROWN INDICATOR

See Figure 2.

To cut base or crown molding in the upright position, align

the arrow on the base/crown indicator with the arrow on

the pivot assembly and tighten the slide lock knob securely.

BEVEL LOCK KNOB

See Figure 3.

The bevel lock knob securely locks your compound miter

saw at desired bevel angles. A positive stop adjustment

screw has been provided on each side of the saw arm.

These adjustment screws are for making fine adjustments

at 0° and 45°.

CARRYING HANDLE

See Figure 3.

For convenience when carrying or transporting the miter

saw from one place to another, a carrying handle has been

provided on top of the saw arm. To transport, turn off and

unplug the saw, then lower the saw arm and lock it in the

down position by depressing the lock pin towards the saw

housing.

NOTE: DO NOT perform any cutting operation with the saw

in the locked position.

DETENT OVERRIDE

See Figure 4.

The detent override allows the miter table to move freely to

any desired angle. With the miter lock handle loosened and

the detent release lever squeezed (1), pull the detent over-

ride up (2) and release the detent release lever (3) to bypass

the positive stops on the miter scale. To release the detent

override and allow the miter table to engage the positive

stops, squeeze and release the detent release lever.

ELECTRIC BRAKE

An electric brake has been provided to quickly stop blade

rotation after the switch is released.

LASER GUIDE

For more accurate cuts, a laser guide is included with the

miter saw. When used properly, the laser guide makes

accurate, precision cutting simple and easy.

SAW ARM LOCKED IN DOWN POSITION

LOCK

CARRYING

HANDLE

“D”

HANDLE

BEVEL

LOCK KNOB

LASER GUIDE

SWITCH

Fig. 3

Fig. 2

LASER GUIDE SWITCH

See Figure 3.

Use the laser guide switch to turn the laser guide on and off.

ALIGN

ARROWS

PIVOT

ASSEMBLY

BASE/CROWN

INDICATOR

SLIDE

LOCK KNOB

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 103 104

Commentaires sur ces manuels

Pas de commentaire

Ryobi TSS120L Manuel d'utilisation et d'entretien Page 9

Commentaires sur ces manuels