Ryobi BS903 Manuel d'utilisateur télécharger pdf (Page 13)

ASSEMBLY

If lag bolts are used, make sure they are long enough to

go through holes in the saw base and material the saw is

being mounted to. If machine bolts are being used, make

sure bolts are long enough to go through holes in the saw

base, the material being mounted to, and the lock washers

and hex nuts.

NOTE: It may be necessary to countersink hex nuts and

washers on bottom side of mounting board.

MOUNTING THE SAW TABLE

See Figures 6 and 7.

 Loosen and remove the table aligning bolt, washer, and

wing nut on the saw table.

 Loosen the table extension knobs beneath the sliding

table extension by turning them clockwise.

 Slide the table extension out and retighten the table

extension knobs.

 Standing at the front of the band saw, slide the saw table

past the blade and through the slot moving from the right

side of the saw table to the left.

 Align the screw holes in the saw table with the holes in

the saw table bracket.

 Using the phillips screws, attach the saw table to the saw

table bracket. Tighten phillips screws securely.

 Close the sliding table extension, retighten the table

extension knobs, then attach the table aligning bolt,

washer, and wing nut to the saw table.

NOTE: The wing nut goes below the saw table.

WING

NUT

WASHER

TABLE

ALIGNING

BOLT

Fig. 7

LOCK

KNOB

BLADE GUIDE

KNOB

Fig. 6

SCREW

SAW

TABLE

BRACKET

SLIDING TABLE

EXTENSION

SAW

TABLE

TABLE EXTENSION

KNOBS

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 25 26

Commentaires sur ces manuels

Pas de commentaire

Ryobi BS903 Manuel d'utilisateur Page 13

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à moteur Ryobi BS903