Ryobi BTS10S Manuel d'utilisateur télécharger pdf (Page 23)

OPERATION

SCREWDRIVER

BEVEL

INDICATOR

SCREW

Fig. 19

Fig. 20

GULLET

TO CHANGE THE BLADE DEPTH

See Figure 19.

The blade depth should be set so that the outer tips of

the blade are higher than the workpiece by approximately

1/8 in. to 1/4 in. but the lowest points (gullets) are below the

top surface. Raise the blade by turning the blade adjusting

handle counterclockwise or lower it by turning the handle

clockwise.

TO CHANGE BEVEL ANGLE

See Figure 20.

This table saw has a rack and pinion bevel control that allows

you to make angled cuts from 90° to 45°.

NOTE: A 90° cut has a 0° bevel and a 45° cut has a 45°

bevel.

 Unplug the saw.

 Loosen bevel control by turning bevel lock lever all the

way to the left. If it needs to be further loosened, pull

spring-loaded bevel lock lever out and rotate it back to

the right. Release bevel locking lever and allow it to seat

(lock) in its original position. Turn it to the left again until

loose.

 Adjust the bevel angle by pushing the wheel in toward the

saw then turning it. Turning the wheel counterclockwise

increases the angle of the blade, bringing it closer to 45°.

Turning it clockwise decreases the angle, bringing the

blade closer to 90°.

 Tighten bevel control by turning bevel lock lever to the

right. If it needs to be tightened more, pull the spring-

loaded bevel lock lever out and rotate it to the left. Then

release bevel lock lever and allow it to return to its original

position. Rotate to the right again. Repeat this process

until bevel lock lever is securely tightened.

NOTE: Prior to making cuts, the bevel lock lever must be

in the locked position as shown in ﬁgure 20.

TO ADJUST THE BEVEL INDICATOR

See Figure 21.

��If the bevel indicator is not at zero when the saw blade is at

90°, adjust the indicator by loosening the screw and setting

it at 0° on the bevel scale. Retighten the screw.

Fig. 21

TO INCREASE

ANGLE

TO DECREASE

ANGLE

11 O’CLOCK IS OPEN, 3 O’CLOCK IS CLOSED

TO LOCK

TO UNLOCK

BEVEL LOCK

LEVER

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 33 34

Commentaires sur ces manuels

Pas de commentaire

Ryobi BTS10S Manuel d'utilisateur Page 23

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à moteur Ryobi BTS10S