Ryobi BTS10S Manuel d'utilisateur télécharger pdf (Page 29)

OPERATION

NON-THROUGH CUT

BLADE

GUARD

REMOVED

TO MAKE A NON-THROUGH CUT

See Figure 32.

Non-through cuts can be made with the grain (ripping) or

across the grain (cross cut). The use of a non-through cut

is essential to cutting grooves. DO NOT perform bevel non-

through cuts on this machine.

NOTE: This is the only type of cut that is made without the

blade guard assembly installed. Make sure the blade guard

assembly is reinstalled upon completion of this type of cut.

DO NOT install dado blades on this machine.

Read the appropriate section which describes the type

of cut in addition to this section on non-through cuts. For

example, if your non-through cut is a straight cross cut, read

and understand the section on straight cross cuts before

proceeding.

WARNING:

When making a non-through cut, the cutter is covered

by the workpiece during most of the cut. Be alert to the

exposed cutter at the start and ﬁnish of every cut to avoid

the risk of serious personal injury.

WARNING:

Never feed wood with your hands when making any non-

through cut such as rabbets. To avoid personal injury, al-

ways use push blocks, push sticks, and featherboards.

 Unplug the saw.

 Remove the blade guard assembly by removing the two

socket head cap screws, lock washers, and ﬂat washers.

 Set the blade to 0º.

 Set the blade to the correct depth for the workpiece.

 Plug the saw into the power source.

 Turn the saw ON.

 Feed the workpiece into the blade.

NOTE: Always use push blocks, push sticks, and

featherboards when making non-through cuts to avoid

the risk of serious injury.

 When the cut is made, turn the saw OFF. Wait for the

blade to come to a complete stop before removing any

part of the workpiece.

Once all non-through cuts are complete:

 Unplug the saw.

 Lower the blade and reinstall the blade guard assembly

using the two socket head cap screws, lock washers,

and ﬂat washers.

Fig. 32

PUSH

STICK

1 2 ... 24 25 26 27 28 29 30 31 32 33 34

Commentaires sur ces manuels

Pas de commentaire

Ryobi BTS10S Manuel d'utilisateur Page 29

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à moteur Ryobi BTS10S