Ryobi P551 Manuel d'utilisateur télécharger pdf (Page 19)

ASSEMBLY

DANGER:

Laser radiation. Avoid direct eye contact with light source.

WARNING:

Use of controls or adjustments or performance of pro-

cedures other than those specified herein may result in

hazardous radiation exposure.

ALIGNING THE LASER GUIDE LINE

See Figure 24.

Draw a line on the workpiece. When the laser guide switch

is turned on it will generate a red line on the work surface.

This line will let you see your mark and the laser guide line

at the same time, and will assist you in lining up the mark

for more accurate cutting of the workpiece.

Align the laser line and the mark with the blade at the

uppermost position. Once both lines are in alignment, do

not move the workpiece.

Make several practice cuts on different styles and thickness

of material. Repeat the steps above as necessary.

Follow the directions below for using the laser guide.

Removing your mark:

Position the laser line near the left edge of your mark on the

work surface in order to remove the mark.

To cut your mark:

Position the laser line near or over your mark on the work

surface in order to cut the mark.

To leave your mark:

Position the laser line near the right edge of your mark on

the work surface in order to leave the mark.

After you have become familiar with using the laser guide,

you will be able to remove, cut, or leave your mark on the

work surface. Practice will teach you the correct position

for aligning the laser line with your mark.

Fig. 24

Laser Line

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 31 32

Pas de commentaire

Ryobi P551 Manuel d'utilisateur Page 19