Ryobi SAW BT3100 Manuel d'utilisateur télécharger pdf (Page 29)

Page 29

OPERATION

■ Remove miter fence, sliding miter table, and accessory

table.

■ Replace accessory table on the left side of blade. Do not

lock.

■ Place the wooden insert between the accessory table and

the saw table to support the workpiece.

See Figure 40

Secure the wooden insert with screws as noted below.

Adjust the accessory table firmly against the wooden

insert and lock securely.

Note: The wooden insert should be attached with wood

screws from the bottom, through the two holes provided

in the casting. Securely trap the wooden insert between

the accessory table and the saw table.

■ Place sliding miter table on the right side of blade and lock

securely.

■ Attach the rip fence over the front and rear rails on the left

side and lock securely. Reset the scale to the blade if

needed.

TO MAKE A BEVEL CROSS CUT

See Figure 39.

It is recommended that you place the piece to be saved on

the left side of the blade and that you make a test cut on

scrap wood.

WARNING:

Make sure the blade guard assembly is installed and

working properly to avoid serious personal injury.

■ Remove the rip fence by lifting the locking handle.

■ Move the bevel locking lever to the right for Angle mode.

Turn the blade adjustment handle until the bevel indicator

is at the desired angle. Push the bevel locking lever

securely to the left to lock the angle.

■ Set the blade to the correct depth for the workpiece.

■ Loosen the adjusting clamp on the miter fence. Set the

miter fence to 90° with either the quick-stop or the miter

scale.

■ Make sure the miter fence will not contact the blade as

the wood feeds into the blade. Make a trial pass of the

miter table. The end of the miter fence should not contact

the blade. Loosen the adjusting clamp to move it away

from the blade if needed.

■ Place a support (the same height as saw table) behind

the saw for the cut work.

■ Make sure the wood is clear of the blade before turning

on the saw.

■ Let the blade build up to full speed before moving the

miter table to feed the workpiece into the blade.

■ Hold the work with both hands and push the miter table

to feed the work into the blade.

TO MAKE A BEVEL RIP CUT

See Figure 40.

It is recommended you make test cuts on scrap wood.

WARNING:

The rip fence must be on the left side of the blade to avoid

trapping the wood and causing kickback. Placement of

the rip fence to the right of the blade will result in kickback

and the risk of serious personal injury.

WARNING:

Make sure the blade guard assembly is installed and

working properly to reduce the risk of serious personal

injury.

Before making this cut, use scrap wood to make an insert

5 in. wide, 22 in. long, and 3/4 in. thick. You may want to

make others that are more than 5 in. wide.

Fig. 39

MITER FENCE

ADJUSTING CLAMP

Fig 40

RIP FENCE

MITER TABLE

WOODEN INSERT

BEVEL LOCKING LEVER

QUICK STOP

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 51 52

Commentaires sur ces manuels

Pas de commentaire

Ryobi SAW BT3100 Manuel d'utilisateur Page 29

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à moteur Ryobi SAW BT3100