Ryobi SAW BT3100 Manuel d'utilisateur télécharger pdf (Page 33)

Page 33

GENERAL MAINTENANCE

WARNING:

Always begin by disconnecting the power supply.

■ Periodically check all clamps, nuts, bolts, screws, and

belts for tightness and condition. Make sure the throat

plate is in good condition and in position.

■ Check the blade guard assembly.

MAINTENANCE

■ To maintain the table surfaces, fence, and rails, periodically

apply paste wax to them and buff to provide smooth

functioning. To prevent work from slipping during cutting

operation, DO NOT wax the working face of the miter

fence.

■ Protect the blade by cleaning out sawdust from underneath

the table and in the blade teeth. Use a resin solvent on the

blade teeth.

■ Clean plastic parts only with a soft damp cloth. DO

NOT use any aerosol or petroleum solvents.

LUBRICATION

This saw has been lubricated at the factory prior to shipment.

Following extended use, you should inspect and lubricate

the following areas to assure smooth operation.

LOCKER BRACKET ASSEMBLY

See Figure 43.

■ Add dry lube between both bevel gears, the backup

washers and the locker bracket.

■ Add dry lube between threaded hole in motor casting and

threaded elevating shaft.

Recommended Lubricants:

Dry Silicone or Teflon Lubricant

TILT / ELEVATING MECHANISM

See Figure 44.

■ Add dry lube between the handle shaft and the bore of the

clamping bolt.

■ Add dry lube between the face of the clamping bolt and the

face of the handle shaft.

■ Add dry lube on the inner surfaces of the bevel locking

lever which contacts the cam.

Fig. 43

BLADE

ADJUSTING HANDLE

HANDLE SHAFT

CLAMPING BOLT

CAM SURFACE

CAM

BEVEL

LOCKING LEVER

Fig. 44

SPRING

BACKUP WASHER

LOCKER BRACKET

BEVEL GEAR

THREADED HOLE

ELEVATING SHAFT

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 51 52

Commentaires sur ces manuels

Pas de commentaire

Ryobi SAW BT3100 Manuel d'utilisateur Page 33

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à moteur Ryobi SAW BT3100