Ryobi TS1342L Manuel d'utilisateur télécharger pdf (Page 24)

OPERATION

 Grasp the stock ﬁrmly with one hand and secure it against

the fence. Use the optional work clamp or a C-clamp to

secure the workpiece when possible.

 Before turning on the saw, perform a dry run of the cutting

operation just to make sure that no problems will occur

when the cut is made.

 Grasp the “D” handle ﬁrmly then squeeze the switch trigger.

Allow several seconds for the blade to reach maximum

speed.

 Slowly lower the blade into and through the workpiece.

 Release the switch trigger and allow the saw blade to stop

rotating before raising the blade out of workpiece. Wait

until the electric brake stops blade from turning before

removing the workpiece from miter table.

TO SUPPORT LONG WORKPIECES

See Figure 30.

Long workpieces need extra supports. Supports should be

placed along the workpiece so it does not sag. The support

should let the workpiece lay ﬂat on the base of the saw and

work table during the cutting operation. Use the optional

work clamp or a C-clamp to secure the workpiece.

Fig. 30

Fig. 29

45° x 45° coMpound Miter cut

Long

workpiece

SupportS

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 30 31 32

Pas de commentaire

Ryobi TS1342L Manuel d'utilisateur Page 24