Ryobi TS1342L Manuel d'utilisateur télécharger pdf (Page 30)

MAINTENANCE

LaSer guide

Support

batterieS

CHANGING THE BATTERIES

See Figure 37.

 Unplug the saw.

Remove the laser guide from the saw and lay it on a ﬂat

surface with the two screws facing upward.

Remove the screws and separate the laser guide cover

from the laser guide support.

Remove the two button cell batteries using a non-con-

ductive device such as a toothpick.

NOTE: Replace the batteries with silver oxide batteries that

have a rating of 1.5 volt and 180 mah (milliampere hour)

minimum (Number 357 silver oxide only).

When replacing the batteries, the laser guide should be

thoroughly cleaned. Use a soft paintbrush or similar device,

to remove all sawdust and debris.

Do not attempt to activate the laser.

The laser is activated by means of a centrifugal switch

only while the saw motor is running and the laser guide is

mounted on the saw.

After cleaning the laser guide and replacing the batteries,

secure the laser guide cover to laser guide support using

the two screws. For proper assembly, be sure to align

the key on the laser guide cover with the key slot in the

laser guide support. Tighten screws securely.

NOTE: Aperture in laser guide cover must be aligned with

aperture in laser guide support.

WARNING:

Use of controls or adjustments or performance of

procedures other than those speciﬁed herein may result

in hazardous radiation exposure.

Fig. 37

ScrewS

LaSer guide

cover

aperture

1 2 ... 25 26 27 28 29 30 31 32

Pas de commentaire

Ryobi TS1342L Manuel d'utilisateur Page 30