Ryobi Drill Press Manuel de l'opérateur télécharger pdf (Page 12)

ADJUSTMENTS

Fig. 11

TABLE ADJUSTMENT

HANDLE

TABLE LOCK

HANDLE

WARNING:

Before performing any adjustment, make sure the drill

press is unplugged from the power supply and the switch

is in the OFF position. Failure to heed this warning could

result in serious personal injury.

ADJUSTING TABLE HEIGHT

See Figure 11.

■ Hold the table with one hand then loosen the table lock

handle.

■ To raise the table, turn the table adjustment handle

clockwise.

■ To lower the table, turn the table adjustment handle

counterclockwise.

■ Once the table is in the desired position, retighten the

table lock handle.

BEVEL ADJUSTMENT

See Figure 12

Your drill press is equipped with a tilting table that allows you

to drill angled holes. The table can be tilted left or right, from

0°-45°.

To tilt the table:

■ Loosen the large hex bolt located beneath the table.

■ Use the bevel scale to tilt the table to the desired angle.

■ Retighten the hex bolt securely.

Fig. 12

HEX

BOLT

BEVEL

SCALE

TABLE LOCK

HANDLE

Fig. 13

DEPTH STOP

DEPTH

GAUGE

DEPTH STOP ADJUSTMENT

See Figure 13.

Where a number of holes are to be drilled to exactly the same

depth, the depth stop is used as follows.

■ Loosen depth stop.

■ Rotate depth gauge clockwise to desired measurement.

■ Retighten depth stop securely. This will stop the spindle

assembly at desired depth.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18

Commentaires sur ces manuels

Pas de commentaire

Ryobi Drill Press Manuel de l'opérateur Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Ryobi Drill Press