Ryobi JM81-1 Manuel de l'opérateur télécharger pdf (Page 20)

Page 20

PROBLEM SOLUTION

A. Biscuit slots are too deep or too shallow. Make fine

adjustments to depth setting. See "TO MAKE FINE

ADJUSTMENTS" section on page 9.

B. Biscuit thickness may be out of tolerance. Compress

biscuits in a vise if they are too thick.

C. Check to see if biscuits are the correct size for the

size slots that have been cut: #0, #10, or #20.

D. Check to see if biscuits have gotten wet and swollen.

1. Biscuits do not fit slots. Biscuits not fitting slots may

also cause misalignment of boards being joined.

2. Wood particles begin to backup on front of unit. A. Dust collection system is not functioning properly.

Dust bag may be full. Empty dust bag often. See

"TO EMPTY DUST BAG" and "TO INSTALL DUST

BAG" sections on page 16.

B. The tunnel in the base may be clogged preventing

wood particles from being drawn into the dust bag.

Remove front and rear base assemblies and clean

blade, bearing plate, base assembly slots, and

surrounding areas. See "CLEANING BASE

ASSEMBLY / DUST BAG TUNNEL" section on

page 17.

3. Blade becomes difficult to push in when cutting

slots. Blade does not retract properly when cutting

slots.

A. Wood particles and resin have built up on base

assembly slots and surrounding areas. Remove

front and rear base assemblies and clean blade,

bearing plate, base assembly slots and surrounding

areas. Apply a thin coat of general purpose grease

in slots or on bearing plate where base slides. See

"CLEANING BASE ASSEMBLY / DUST BAG

TUNNEL" section on page 17.

4. Cutting performance is poor and there is a loss of

power or stalling of motor when cutting slots.

A. Blade is dull. Replace blade. See "BLADE

REPLACEMENT" section on pages 18 and 19.

B. Resin has built up on blade. Remove blade and

clean blade with gum and pitch remover. See

"BLADE REPLACEMENT" section on pages 18

and 19 for removing blade to clean and replacing

blade.

TROUBLESHOOTING

1 2 ... 15 16 17 18 19 20 21 22

Commentaires sur ces manuels

Pas de commentaire

Ryobi JM81-1 Manuel de l'opérateur Page 20

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Ryobi JM81-1