Ryobi P507 Manuel d'utilisation et d'entretien télécharger pdf (Page 10)

10 - English

NOTE: Always raise the lower blade guard with the handle

to avoid serious injury.

 Hold the lower blade guard by the handle.

WARNING:

Never extend your fingers while holding the lower blade

guard handle. Extending your fingers could result in

contact with the blade, causing serious injury.

 Rest the front of the base flat against the workpiece with

the rear of the handle raised so the blade does not touch

the workpiece.

 Start the saw and let the blade reach full speed.

 Guide the saw into the workpiece and make the cut.

OPERATION

WARNING:

Always cut in a forward direction when pocket cutting.

Cutting in the reverse direction could cause the saw to

climb up on the workpiece and back toward you.

 Release the trigger and allow the blade to come to a

complete stop.

 Lift the saw from the workpiece.

 Clear corners out with a hand saw or sabre saw.

WARNING:

Never tie the lower blade guard in a raised position.

Leaving the blade exposed could lead to serious injury.

ADJUSTMENTS

WARNING:

To prevent accidental starting that could cause serious

personal injury, always remove the battery pack from the

product when making adjustments.

0° BEVEL STOP

See Figure 20, page 14.

The saw has a 0° bevel stop that has been factory adjusted

to assure 0° angle of the saw blade plate when making 90°

cuts.

CHECKING 0° BEVEL STOP

 Remove battery pack.

 Place the saw in an upside down position on a workbench.

 Check the squareness of the saw blade plate to the base

of the saw using a carpenter’s square.

ADJUSTING 0° BEVEL STOP

 Remove battery pack.

 Loosen bevel lock knob.

 Loosen hex nut securing adjusting screw.

 Turn adjusting screw and adjust base until square with

saw blade.

 Tighten hex nut and bevel lock knob securely.

WARNING:

Attempting a bevel cut without having the bevel adjust-

ment knob securely tightened can result in serious injury.

WARNING:

This product and some dust created by power sanding, sawing, grinding, drilling, and other construction activities may

contain chemicals, including lead, known to the State of California to cause cancer, birth defects, or other reproductive

harm. Wash hands after handling.

Some examples of these chemicals are:

• lead from lead-based paints,

• crystalline silica from bricks and cement and other masonry products and,

• arsenic and chromium from chemically treated lumber.

Your risk from exposure to these chemicals varies, depending on how often you do this type of work. To reduce your

exposure, work in a well-ventilated area and with approved safety equipment, such as dust masks that are specially

designed to filter out microscopic particles.

CALIFORNIA PROPOSITION 65

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 35 36

Commentaires sur ces manuels

Pas de commentaire

Ryobi P507 Manuel d'utilisation et d'entretien Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Ryobi P507