Ryobi P507 Manuel d'utilisation et d'entretien télécharger pdf (Page 7)

7 - English

 Return the blade wrench to the storage area.

NOTE: Never use a blade that is too thick to allow the outer

blade washer to engage with the flats on the spindle.

REMOVING THE BLADE

See Figure 2, page 12.

 Remove the battery pack from the saw.

ASSEMBLY

Remove the blade wrench from the storage area.

Position the saw as shown, depress the spindle lock but-

ton and remove the blade screw by turning it clockwise.

Remove the outer blade washer.

Remove the blade.

OPERATION

WARNING:

Do not allow familiarity with products to make you care-

less. Remember that a careless fraction of a second is

sufficient to inflict serious injury.

WARNING:

Always remove battery pack from the tool when you are

assembling parts, making adjustments, cleaning, or when

not in use. Removing battery pack will prevent accidental

starting that could cause serious personal injury.

WARNING:

Always wear eye protection with side shields marked to

comply with ANSI Z87.1. Failure to do so could result in

objects being thrown into your eyes resulting in possible

serious injury.

APPLICATIONS

You may use this product for the purposes listed below:

Cutting all types of wood products (lumber, plywood,

paneling, composition board, and hardwood)

WARNING:

Never use abrasive cut-off wheels of any kind with this

saw. Use of non wood cutting blades can result in prop-

erty damage or serious personal injury.

INSTALLING THE BATTERY PACK

See Figure 3, page 12.

 Place the battery pack in the saw. Align the raised rib

on the battery pack with the groove inside the saw, then

slide the battery pack into the saw.

 Make sure the latches on each side of your battery pack

snap into place and the battery pack is secured in the

saw before beginning operation.

REMOVING THE BATTERY PACK

See Figure 3, page 12.

 Locate the latches on the side of the battery pack and

depress them to release the battery pack from the saw.

WARNING:

Battery tools are always in operating condition. Lock

the switch when not in use or carrying at your side,

when installing or removing the battery pack, and when

installing or removing blades.

KICKBACK

See Figures 4 - 7, pages 12 and 13.

Kickback occurs when the blade stalls rapidly and the saw

is driven back towards you. Blade stalling is caused by any

action which pinches the blade in the wood.

DANGER:

Release switch immediately if blade binds or saw stalls.

Kickback could cause you to lose control of the saw. Loss

of control can lead to serious injury.

To guard against kickback, avoid dangerous practices

such as the following:

Setting blade depth incorrectly.

Sawing into knots or nails in workpiece.

Twisting the blade while making a cut.

Making a cut with a dull, gummed up, or improperly set

blade.

Supporting the workpiece incorrectly.

Forcing a cut.

Cutting warped or wet lumber.

Operating the tool incorrectly or misusing the tool.

To lessen the chance of kickback, follow these safety

practices:

Keep the blade at the correct depth setting. The depth

setting should not exceed 1/4 in. below the material being

cut.

1 2 3 4 5 6 7 8 9 10 11 12 ... 35 36

Commentaires sur ces manuels

Pas de commentaire

Ryobi P507 Manuel d'utilisation et d'entretien Page 7

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Ryobi P507