Ryobi P531 Manuel d'utilisation et d'entretien télécharger pdf (Page 6)

NOTICE:

We suggest that you practice with your speed saw before

installing a bit and making cuts.

OPERATING THE SPEED SAW

See Figure 4, page 8.

Hold speed saw firmly.

Start speed saw.

Tilt speed saw at a 45

angle.

Plunge bit into material using guide ring as a pivot.

Raise speed saw slowly to a 90

angle.

Begin cutting.

DANGER:

Do not cut electrical outlet openings with live electrical

wires. Do not cut walls that could have live electrical

wiring behind them. Shut off breakers or remove fuses to

disconnect the circuit. Always hold the tool by its motor

housing.

ADJUSTING DEPTH OF CUT

See Figure 5, page 9.

Remove battery pack.

Loosen adjusting knob by turning counterclockwise.

Move depth adjustment ring to desired position.

Tighten adjusting knob by turning clockwise.

REMOVING DEPTH ADJUSTMENT RING

See Figure 6, page 9.

Remove battery pack from speed saw.

Place wrench in tab on depth adjustment ring.

Depress spring-loaded tab.

Lift depth adjustment ring off tool.

INSTALLING/REMOVING BITS

See Figure 3, page 8.

Remove battery pack from speed saw.

NOTE: The collet is machined to precision tolerances

to fit bits with 1/4 in. diameter shanks. To use bits with

1/8 in. shank bits, remove the collet nut and insert the

1/8 in. adaptor into the 1/4 in. collet. Replace the collet

nut before inserting the bit.

NOTICE:

To prevent damage to the spindle or spindle lock, always

allow motor to come to a complete stop before engaging

spindle lock.

Depress spindle lock.

Loosen collet nut by turning counterclockwise with the

wrench provided.

WARNING:

If you are changing a bit immediately after use, be careful

not to touch the bit or collet with your hands or fingers.

You could get burned because of the heat buildup from

cutting. Always use the wrench provided.

To insert bit: Insert shank end of bit into collet.

To remove bit: Remove bit once collet nut is loose.

Tighten collet nut securely by turning clockwise with the

wrench provided.

WARNING:

If the collet nut is not securely tightened, the bit can de-

tach during use causing serious personal injury.

Release spindle lock.

WARNING:

Do not use bits with undersized shanks. Undersized

shanks will not tighten properly and could be thrown from

the tool causing injury.

OPERATION

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

Commentaires sur ces manuels

Pas de commentaire

Ryobi P531 Manuel d'utilisation et d'entretien Page 6

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Ryobi P531