Ryobi RY43200 Manuel de l'opérateur télécharger pdf (Page 4)

Page 4 — English

Do not abuse the cord. Never use the cord to

carry the product or to disconnect the plug from

an outlet. Keep cord away from heat, oil, sharp

edges, or moving parts. Replace damaged

cords immediately. Damaged cords increase

the risk of electric shock.

Make sure your extension cord is in good

condition. When using an extension cord, be

sure to use one heavy enough to carry the

current your product will draw. A wire gauge

size (A.W.G.) of at least 16 is recommended for

an extension cord 50 feet or less in length. If in

doubt, use the next heavier gauge. The smaller

the gauge number, the heavier the cord. An

undersized cord will cause a drop in line voltage

resulting in loss of power and overheating.



WARNING: Use outdoor extension cords marked

SW-A, SOW-A, STW-A, STOW-A, SJW-A,

SJTW-A, or SJTOW-A. These cords are rated for

outdoor use and reduce the risk of electric shock.

Ground Fault Circuit Interrupter (GFCI) protection

should be provided on the circuit(s) or outlet(s)

to be used for the product. Receptacles are

available having built-in GFCI protection and

may be used for this measure of safety.

DANGER — Keep hands away from blade.

Contact with blade will result in serious personal

injury.

Kickback is a dangerous reaction that can lead

to serious injury. Kickback may occur when the

moving chain contacts an object at the upper

portion of the tip of the guide bar or when the

wood closes in and pinches the chain in the

cut. Contact at the upper portion of the tip of

the guide bar can cause the chain to dig into

the object and stop the chain for an instant.

The result is a lightning-fast, reverse reaction

which kicks the guide bar up and back toward

the operator. If the chain is pinched along the

top of the guide bar, the guide bar can be driven

rapidly back toward the operator, which can

cause loss of control and may result in serious

injury. Do not rely exclusively upon the safety

devices built into the product.

With a basic understanding of kickback, you

can reduce or eliminate the element of surprise.

Sudden surprise contributes to accidents.

Use lopper for cutting wood only. Do not use

for cutting non-wood items.

Make sure that the area in which you are cutting

is free from obstructions. Do not let the nose of

the guide bar contact a log, branch, fence, or

any other obstruction while you are operating

the unit. Have a planned retreat path.

Do not grasp the exposed cutting blades or

cutting edges when picking up or holding the

product.

Cut only when visibility and light are adequate

for you to see clearly.

To protect yourself from electrocution, do not

operate within 50 feet of overhead electrical

lines.

Before starting the motor, make sure the chain

is not contacting any object.

 Do not operate the lopper if either the upper or

lower guards are broken, cracked, missing, or

damaged in any way.

To protect yourself from falling branches, do not

stand directly under the branch or limb being

cut. This unit should not be held at an angle over

60° from ground level.

Keep unit clean of clippings and other materials.

They may become lodged between the jaw and

blade.

Turn off the motor and make sure cutting

attachment has stopped before setting unit

down.

Follow the sharpening and maintenance

instructions for the saw chain.

Use only the replacement guide bars and low

kickback chains specified for the unit.

IMPORTANT SAFETY INSTRUCTIONS

SPECIFIC SAFETY RULES

1 2 3 4 5 6 7 8 9 ... 67 68

Commentaires sur ces manuels

Pas de commentaire

Ryobi RY43200 Manuel de l'opérateur Page 4

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Ryobi RY43200