Ryobi Trimmer p600 Manuel d'utilisateur télécharger pdf (Page 14)

1/4

1/2

3/4

1/4

1/2

3/4

OPERATION

OPTIONAL WOODWORKING SUB-BASE

Turn the P600 laminate trimmer into a trim router with the op-

tional woodworking sub-base, Ryobi Part No. 200334001.

The woodworking sub-base accessory with handles is con-

venient when routing 4 in., 5 in., or 6 in. circular grooves. It

can also be used when routing grooves parallel to the edge

of the workpiece or with ball-bearing piloted bits.

The handles allow you to grasp and hold the trimmer with

two hands, similar to grasping and holding a router.

This trimmer is designed for roundover and other edging

operations up to 3/8 in. It is also useful for rabbeting or dado

operations with straight bits up to a maximum diameter of

1/4 in.

WARNING:

Do not use straight bits larger than 1/4 in. or edging bits

which cut a pattern larger than 3/8 in. with this trimmer.

Use of larger bits can result in loss of control and serious

personal injury.

WARNING:

Always use the laminate sub-base for laminate trimming.

Always use the woodworking sub-base for trim routing

operations. Use of the trimmer without a sub-base or us-

ing the incorrect sub-base can result in serious personal

injury.

WARNING:

Never install a bit larger than the opening of the trimmer

base. The use of larger bits can result in loss of control

and possible serious personal injury.

ATTACHING THE WOODWORKING SUB-BASE

ACCESSORY

AND HANDLES

See Figure 10.

 Turn the switch to OFF and remove the battery pack from

the trimmer.

 Turn the trimmer upside down to remove the four sub-

base screws and laminate sub-base.

 Attach the woodworking sub-base accessory using the

same four screws.



Tighten the screws securely. Do not overtighten.

 Turn the trimmer upright and thread the handles provided

into the threaded holes in the woodworking sub-base

accessory.

Tighten the handles securely. Check often to assure the

handles remain securely tightened.

Fig. 11

WORKPIECE

FINISHING

NAIL

ROUT CIRCULAR GROOVE CLOCKWISE

Fig. 10

SUB-BASE

SCREW(S)

WOODWORKING

SUB-BASE

ACCESSORY

HANDLE(S)

TRIMMER

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 61 62

Commentaires sur ces manuels

Pas de commentaire

Ryobi Trimmer p600 Manuel d'utilisateur Page 14

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Ryobi Trimmer p600