Ryobi Trimmer p600 Manuel d'utilisateur télécharger pdf (Page 15)

OPERATION

Fig. 12

ROUT GROOVE FROM RIGHT TO LEFT

ROUTING GROOVES IN A CIRCLE

See Figure 11.

 There are three holes marked R2", R2-1/2", and R3" on

the woodworking sub-base. Each number represents a

radius and may be used when cutting circular grooves

that are 4 in., 5 in. or 6 in. in diameter.

 Select the radius for the desired circle, place a finish-

ing nail through the hole and securely tack it into the

workpiece. This will create a pivot axis for that size ra-

dius.

 Rout a circular groove in a clockwise direction only.

ROUTING GROOVES PARALLEL TO AN EDGE

See Figures 12 - 13.

You can use the scale provided on the woodworking sub-

base accessory to cut a straight parallel line up to 1 in. from

the edge of the workpiece.

 The intersection of the horizontal and vertical lines at the

center of the woodworking sub-base accessory indicates

the center of the cutter. This is also the center of groove

being cut.

 For grooves more than 1 in. from the edge of workpiece,

align the center of desired groove on the workpiece with

the centerline on the woodworking sub-base accessory.

Then measure from the centerline on the woodworking

sub-base accessory to the guiding portion of the straight

guide. Tighten the knob on the straight guide securely.

 Using “C” clamps and a board to act as the straight edge,

place the cutter at the desired position on the workpiece

and make the cut from right to left.

NOTE: The board being used as a straight edge must be

1/4 in. thick to prevent contact with the trimmer base. It

must also be at least as long as the workpiece in order

to be a guide.

 The thrust is from the trimmer against the straight

edge.

 Do not make a cut that is too heavy in one pass. If a deep

cut is required, make successive passes at increasing

depths with each new pass until you reach the desired

groove depth.

WARNING:

If the desired depth of cut is greater than can be safely

cut in one pass, make cuts in two or more passes. Do

not remove more than 1/8 in. in a single pass. Excessive

depth of cut can result in loss of control and the possibility

of serious personal injury.

Fig. 13

TRIM ROUTER USED WITH A BALL-BEARING GUIDED BIT

1/4

1/2

3/4

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 61 62

Commentaires sur ces manuels

Pas de commentaire

Ryobi Trimmer p600 Manuel d'utilisateur Page 15

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Ryobi Trimmer p600