Ryobi 4950301 Manuel d'utilisateur télécharger pdf (Page 10)

Page 10

Fig. 9

Fig. 10

4–HOLE ROUTER WITH MOUNTING PLATE ATTACHED

ROUTER

MOUNTING

SCREWS

FRONT

OF ROUTER

ROUTER

MOUNTING

PLATE

ROUTER WITH 4–HOLE PATTERN

TO ASSEMBLE ROUTERS WITH 4-HOLE

PATTERN TO ROUTER MOUNTING PLATE:

See Figures 9 and 10.

For Ryobi routers, model numbers RE600 and RE601.

■ Unplug the router.

WARNING:

Unplug the router to avoid possible injury.

■ Make sure the router switch is OFF and the router is

not connected to a power source.

■ Place the router upside down on a workbench and

remove the subbase screws and subbase from the

router.

■ Align mounting holes of the mounting plate with the

four threaded holes in the router base.

■ The switch handle of the router should be facing the

squared end of the mounting plate.

See Figure 9.

■ Secure the router mounting plate to the router using

four M8 flat head screws provided in the router

mounting kit. Tighten screws securely.

■ Properly installed, the mounting plate will be securely

attached to the router.

See Figure 10.

NOTE: The clearance needed for mounting a router

to the table creates a gap between the accessory

table and the saw table. This gap must be filled with

a 22 in. wooden insert of appropriate width. This

insert should be 1-1/2 in. thick. Place this wooden

insert in the gap, level with the accessory table.

Assure that the insert does not interfere with the rip

fence. The rip fence should be positioned over the

accessory table and the wooden insert, as

appropriate.

See Figures 2 and 3.

ROUTER

BASE

ASSEMBLY

WARNING:

Any gap between the tables resulting from the router

set up must be filled to reduce the risk of serious

injury.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

Ryobi 4950301 Manuel d'utilisateur Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Routeurs Ryobi 4950301