Ryobi 4950301 Manuel d'utilisateur télécharger pdf (Page 12)

Page 12

ROUTER MOUNTING

around the raised portion on the underside of the

accessory table, clamping it tightly against the rear

rail.

■ Secure with a 5/16 in. washer and 5/16-18 x 3/4 in.

knob bolt.

■ Tighten knob bolt securely.

FINAL ASSEMBLY:

After the router mounting parts have been assembled,

your setup should be similar to

Figure 13.

■ Compare your setup and make any necessary

adjustments.

■ Recheck all knob bolts, attachments, etc., and

securely tighten.

Fig. 13

DIRECTION OF FEED IS FROM RIGHT TO LEFT

AGAINST SHARP EDGES OF ROTATING BIT

ROUTER KIT SHOWN COMPLETELY ASSEMBLED

WARNING:

The direction of feed for the workpiece is always

against the sharp edges of the bit and into the

rotation of the cutter. Failure to heed this warning can

result in serious personal injury.

WARNING:

Do not use the guide fence with ball-bearing piloted

bits. Failure to heed this warning can result in serious

personal injury.

WARNING:

The guard/dust cover must be used in all routing

operations. Do not attempt freehand use on

workpieces larger than 6 in. (15 cm) in diameter.

OPERATION

FINAL PREPARATION FOR OPERATION

See Figure 13.

■ Adjust dust cover so that it will not come in contact

with workpiece during a cutting operation.

■ Direction of feed of workpiece is from right to left as

shown by the arrows in figure 13.

■ The workpiece must always

be tight against the

guide fence, unless a ball bearing piloted bit is being

used. The infeed fence should be adjusted to support

the uncut workpiece while the outfeed fence should

be adjusted to properly support the workpiece after

the cut passes the router bit, compensating for the

removed stock.

1 2 ... 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

Ryobi 4950301 Manuel d'utilisateur Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Routeurs Ryobi 4950301