Ryobi BGH616 Manuel d'utilisateur télécharger pdf (Page 12)

WaSHer

CarriaGe

bolt

WorK

reSt

aSemblY

Fig. 6

Knob

ASSEMBLY

MOUNTING WORK REST

See Figure 6.

 Remove the knob, star washer, and washer from the car-

riage bolt on the lower portion of wheel guard.

 Using the slotted screw, star washer, washer and fasten-

ing knob, attach the work rest bracket to the inside of the

wheel guard as shown.

NOTE: The grooved work rest mounts on the left side.

NOTE: The work rest bracket's lower slot must be posi-

tioned over the pin on the guard.

 With the remaining fastening knob, install the work rest

to the bracket.

NOTE: Adjust the distance between the wheel and the work

rest to maintain 1/16 in. or less separation as the diameter

of the wheel decreases with use.

WARNING:

Always make sure your bench grinder is securely

mounted to a workbench. Failure to do so could result

in an accident resulting in possible serious personal

injury.

MOUNTING GRINDER TO WORKBENCH

See Figure 7.

If grinder is to be used in a permanent location, it should be

fastened securely to a firm supporting surface, such as a

workbench with bolts.

 Use 1/4 in. bolts, washers, and nuts (not included). The

bolt length should be 1-1/2 in. plus the thickness of the

workbench.

 Locate and mark the holes where the grinder is to be

mounted.

 Drill four 3/8 in. diameter holes through workbench.

 Place sander on workbench, aligning holes in base with

holes drilled in workbench.

 Insert four 1/4 in. diameter bolts and washers and attach

nuts securely.

Fig. 7

WorK reSt

(riGHt)

larGe

Knob

WorK reSt

braCKet

Star WaSHer

Fig. 6

HeX nut

loCK

WaSHer

WaSHerS

WaSHer

HeX bolt

WaSHer

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18

Commentaires sur ces manuels

Pas de commentaire

Ryobi BGH616 Manuel d'utilisateur Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Outils Ryobi BGH616