Ryobi CSB141LZ Manuel de l'opérateur télécharger pdf (Page 18)

18 19

OPERATION

CROSS CUTTING/RIP CUTTING

See Figures 18 - 20.

When making a cross cut or rip cut, align the line of cut

with the outer blade guide notch on the base as shown in

the figure.

Since blade thicknesses vary, always make a trial cut in scrap

material along a guideline to determine how much, if any, you

must offset the guideline to produce an accurate cut.

NOTE: The distance from the line of cut to the guideline is

the amount you should offset the guide.

TO RIP CUT WITHOUT EDGE GUIDE

See Figure 19.

Use a guide when making long or wide rip cuts with the

saw.

n Secure the workpiece.

n Clamp a straight edge to the workpiece using

C-clamps.

n Saw along the straight edge to achieve a straight rip

cut.

NOTE: Do not bind the blade in the cut.

TO RIP CUT WITH EDGE GUIDE

See Figure 20.

n Secure the workpiece.

n Position the face of the edge guide firmly against the

edge of workpiece.

n Guide the saw along the edge to achieve a straight rip

cut.

NOTE: The guiding edge of the workpiece must be

straight for your cut to be straight. Use caution to prevent

the blade from binding in the cut.

Fig. 18

TOP VIEW OF SAW

BLADE GUIDE

NOTCH

GUIDELINE

Fig. 20

STRAIGHT

EDGE

C-CLAMPS

WORKPIECE

EDGE GUIDE

WORKPIECE

GUIDELINE

Fig. 19

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24

Commentaires sur ces manuels

Pas de commentaire

Ryobi CSB141LZ Manuel de l'opérateur Page 18

Commentaires sur ces manuels

Produits connexes et manuels pour Scies circulaires Ryobi CSB141LZ