Ryobi P580 Manuel de l'opérateur télécharger pdf (Page 8)

8 — English

ASSEMBLY

WARNING:

Do not use cutting wheels rated less than the no load

speed of this tool. Failure to heed this warning could

result in personal injury. Do not use wheel with cracks,

gaps, or teeth.

WARNING:

Do not use toothed or segmented wheels. Use only

continuous rimmed diamond wheels suited for masonry

materials.

INSTALLING CUTTING WHEEL

See Figure 3, page 13.

 Remove the battery pack from the saw.

Remove the wheel wrench (5 mm hex key) from the stor-

age area.

Depress the spindle lock button and remove the wheel

screw and outer wheel washer.

NOTE: Turn the wheel screw clockwise to remove.

CAUTION:

To prevent damage to the spindle or spindle lock, always

allow motor to come to a complete stop before engaging

spindle lock.

NOTE: Do not run the saw with spindle lock engaged.

Wipe a drop of oil onto the inner wheel washer and outer

wheel washer where they contact the wheel.

WARNING:

If inner wheel washer has been removed, replace it before

placing cutting wheel on spindle. Failure to do so could

cause an accident since wheel will not tighten properly.

 Replace the outer wheel washer.

 Depress the spindle lock button, then replace the wheel

screw. Tighten the wheel screw securely by turning it

counterclockwise.

 Return the wheel wrench to the storage area.

NOTE: Never use a cutting wheel that is too thick to allow

the outer wheel washer to engage with the flats on the

spindle.

WARNING:

Do not attempt to modify this product or create acces-

sories not recommended for use with this product. Any

such alteration or modification is misuse and could result

in a hazardous condition leading to possible serious

personal injury.

WARNING:

Do not install battery until assembly is complete. Failure

to comply could result in accidental starting and possible

serious personal injury.

ATTACHING GRAVITY FEED WATER BOTTLE

See Figure 2, page 13.

The gravity feed water bottle has a built in air vent that equal-

izes pressure and allows water to flow more freely.

 Remove the battery.

 Unscrew the nozzle assembly.

 Fill water bottle to desired level. Do not overfill.

 Replace nozzle assembly.

 Hold water bottle so that nozzle faces down.

NOTE: Water will not escape the bottle unless the tip of

the nozzle is depressed.

 Insert the water bottle as shown. Gently press down on

the bottle until it clicks into place.

 To remove water bottle, depress the water bottle release

button.

NOTE: For dry cutting, leave water bottle installed to prevent

dust and debris from clogging the water supply system.

CAUTION:

Water bottle is designed for water only. Use of any other

fluid may cause damage to the tool.

WARNING:

A 4 in. wheel is the maximum wheel capacity of the saw.

Also, never use a wheel that is too thick to allow outer

wheel washer to engage with the flat on the spindle.

Larger wheels will come in contact with the wheel guards,

while thicker wheels will prevent wheel screw from se-

curing wheel on spindle. Either of these situations could

result in a serious accident.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 39 40

Commentaires sur ces manuels

Pas de commentaire

Ryobi P580 Manuel de l'opérateur Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Scies circulaires Ryobi P580