Ryobi RGBV3100 Manuel d'utilisateur télécharger pdf (Page 9)

STARTING/STOPPING INSTRUCTIONS

STARTING INSTRUCTIONS

1. Mix petrol (gasoline) with oil. Fill petrol tank with

petrol/oil mixture. See Oil and Petrol Mixing

Instructions.

WARNING: To avoid serious personal injury,

always remove the vacuum bag prior to

refueling the unit. The bag may become a

fire hazard when saturated with petrol.

NOTE: Have the shoulder harness on and adjusted, but

not clipped to the support fitting prior to starting

unit.

NOTE: Fast position is to the right. The throttle lever will

remain in position until moved.

NOTE: Setting the lever to the blower mode prevents

the vacuum bag from filling up while starting the

engine.

NOTE: The ignition switch is a momentary switch and is

always in th ON (I) position (Fig. 10).

2. Set the blower/vacuum mode change-over lever to

the up position (Blower Mode). See Operating as a

Blower.

3. Fully press and release primer bulb slowly 10 times.

Petrol should be felt and visible in the bulb (Fig. 11).

If petrol hasn’t entered the bulb, press until it does.

4. Place the choke lever in Position A (Fig. 11).

5. With the unit on the ground, move the throttle lever

to the fast position ( ) (Fig. 10).

6. Pull starter rope briskly (Fig. 12). Continue pulling (it

should take 2 to 5 pulls).

7. Place the choke lever in Position B (Fig. 11).

8. Pull starter rope briskly 1 to 3 times to start the

engine (Fig. 12).

9. If the engine does not start, repeat steps 3

through 8.

Ignition Switch

Fig. 10

Throttle Lever

Idle

Fast

AB C

Choke Lever

Position A

Primer Bulb

Fig. 11

Position C

Position B

Starter

Rope

Fig. 12

10. Allow the engine to warm up for 5 to 10 seconds.

Place the choke lever in Position C (Fig. 11).

11. Stand in the operating position and clip the shoulder

harness to the support fitting.

NOTE: If the engine floods while trying to start, place the

choke lever in Position C. Move the throttle lever

to the fast position ( ) (Fig 10). Pull the starter

rope briskly. The engine should start with three

(3) to eight (8) pulls.

NOTE: Choking is unnecessary when starting a warm

engine. Put the throttle lever in the fast position

(

) (Fig 10) and start unit with the choke lever

in Position B (Fig. 11).

STOPPING INSTRUCTIONS

1. Move the throttle lever to the idle position ( )

(Fig. 10). Allow the engine to cool down by

idling.

2. Press and hold the ignition switch down in the

STOP [

] position until the engine comes to a

complete stop (Fig. 10).

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 87 88

Commentaires sur ces manuels

Pas de commentaire

Ryobi RGBV3100 Manuel d'utilisateur Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Ventilateurs Ryobi RGBV3100