Ryobi RY13010 Manuel d'utilisateur télécharger pdf (Page 13)

9 — English

OPERATION

using your left hand, pull the starter grip and rope until

the engine runs.

Set the start lever back to the RUN position.

NOTE: If the engine dies, set the start lever to the RUN

position and pull the starter grip and rope until the engine

starts.

Move to the rear of the machine and squeeze throttle

lever to run.

To start a warm engine:

Move the start lever to the START position and then

immediately back to the RUN position.

NOTE: This will set the carburetor to a fast idle setting

for easier starting.

Pull the starter grip and rope until the engine starts.

To stop the engine:

Place the on/stop switch in the OFF ( O ) position.

CUTTING TIPS

See Figure 13.

 Keep a firm grip with both hands while in operation.

 If grass becomes wrapped around the string head, STOP

THE ENGINE, disconnect the spark plug wire, and remove

the grass.

 Use the tip of line to do the cutting; do not force string

head into uncut grass.

 Wire and picket fences cause extra line wear, even

breakage. Stone and brick walls, curbs, and wood may

wear line rapidly.

 Avoid trees and shrubs. Tree bark, wood moldings, siding,

and fence posts can easily be damaged by the line.

TRANSPORTING THE UNIT

Turn on/stop switch OFF ( O ).

Make sure engine and exhaust are cool.

Keep unit level to prevent fuel spillage.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 43 44

Pas de commentaire

Ryobi RY13010 Manuel d'utilisateur Page 13