Ryobi RY28101 Manuel d'utilisateur télécharger pdf (Page 11)

9 — English

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most

plastics are susceptible to damage from various types of

commercial solvents and may be damaged by their use.

Use clean cloths to remove dirt, dust, lubricant, grease, etc.

WARNING:

Do not at any time let brake fluids, gasoline, petroleum-

based products, penetrating lubricants, etc., come in con-

tact with plastic parts. Chemicals can damage, weaken or

destroy plastic which could result in serious personal injury.

You can often make adjustments and repairs described

here. For other repairs, have the power head serviced by

an authorized service dealer.

STARTING AND STOPPING

See Figures 6 - 8.

Power head should be on a flat, bare surface for starting.

To start a cold engine:

 Slowly press the primer bulb 10 times.

 Set the choke lever to the START (A) position.

 Squeeze the throttle trigger fully and pull the starter handle

until the engine runs. Do not pull the starter grip more

than six (6) times.

NOTE: Keep throttle trigger squeezed fully through re-

maining steps. If the engine does not start, start over at

the first step with pressing the primer bulb.

 Allow the engine to run for 10 seconds, then set the choke

lever to the RUN (B) position.

OPERATION

To restart a warm engine:

 Slowly press the primer bulb 10 times.

 Set the choke lever to the RUN (B) position.

 Squeeze the throttle trigger fully and pull the starter handle

until the engine runs.

To stop the engine:

 To stop the engine, depress the STOP switch to the stop

position “

”.

IF ASSISTANCE IS REQUIRED FOR THIS PRODUCT:

Do not return this product to the retail store where it was

purchased. Please call our Customer Service Department

for any issues you may have.

For Help Call: 1-800-860-4050

MAINTENANCE

WARNING:

When servicing, use only identical replacement parts.

Use of any other parts could create a hazard or cause

product damage.

WARNING:

Always wear eye protection with side shields marked to

comply with ANSI Z87.1, along with hearing protection.

Head protection may also be required depending on the

type of attachment used and as prescribed in the attach-

ment’s Operator’s Manual. Failure to do so could result in

objects being thrown into your eyes and other possible

serious injuries.

WARNING:

Before inspecting, cleaning, or servicing the machine,

shut off engine, wait for all moving parts to stop, and

disconnect spark plug wire and move it away from spark

plug. Failure to follow these instructions can result in

serious personal injury or property damage.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 37 38

Commentaires sur ces manuels

Pas de commentaire

Ryobi RY28101 Manuel d'utilisateur Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel de jardinage Ryobi RY28101