Ryobi EJ101 Manuel de l'opérateur télécharger pdf (Page 15)

Page 15

MAINTENANCE

AIR FILTER MAINTENANCE

See Figure 12.

WARNING:

To avoid serious personal injury, always turn your

saw off and allow it to cool before you clean or do any

maintenance on it.

1. Using a small phillips screwdriver, loosen and remove the

air filter cover screws (2) and air filter cover.

2. Separate and remove the air filter elements (2) from the

plastic air filter element cover and air filter cover support

casing (2 pieces).

3. Inspect elements for dirt, stains, etc.

4. Wash both in gasoline, then squeeze dry.

5. Dip elements in SAE 30 engine oil and squeeze out all

excess.

6. Place air filter elements back in plastic air filter element

cover and support.

7. Place plastic casing on carburetor and align screws holes

in casing with screw holes on carburetor.

8. Position air filter cover on carburetor so that all screw

holes are aligned.

9. Secure all parts to carburetor with air filter cover screws

(2). Tighten securely, but do not over tighten. Plastic parts

will break if screws are too tight.

CAUTION:

Do not sand blast, scrape, or clean electrodes. Grit

in the engine could damage the cylinder.

CLEAN MUFFLER EXHAUST

See Figure 13.

WARNING:

To avoid serious personal injury, always turn your

saw off and allow it to cool before you clean or do any

maintenance on it.

After extended periods of use carbon deposit will build up in

the exhaust port of the muffler, causing it to become clogged.

If this situation occurs, periodically remove the carbon build

up with a slotted screwdriver. Be careful, do not damage the

muffler, piston, or cylinder.

NOTE: If an excessive amount of carbon builds up, causing

a loss of power, take your saw to an authorized service

center to be cleaned by a authorized service technician. It

may be necessary for him to remove the muffler and clean

both the muffler and cylinder.

Fig. 12

Fig. 13

CARBURETOR

AIR FILTER

COVER

SCREWS

AIR FILTER

ELEMENT SUPPORT

AIR FILTER

ELEMENTS

AIR FILTER

ELEMENT COVER

MUFFLER

1 2 ... 10 11 12 13 14 15 16 17 18 19 20

Commentaires sur ces manuels

Pas de commentaire

Ryobi EJ101 Manuel de l'opérateur Page 15

Commentaires sur ces manuels

Produits connexes et manuels pour Tondeuses à gazon Ryobi EJ101