Ryobi DBJ50 Instructions d'exploitation télécharger pdf (Page 130)

Page 121 Power Equipment Usage Manual (Rev. 5/10)

f. DIRECTION OF FEEDING WORK: FEED THE WORKPIECE into cutter rotation direction or

workpiece will shoot out like a missile. Should you reverse the cutter, the feed direction will

also be from the opposite direction.

g. DO NOT ATTEMPT TO REVERSE YOUR DIRECTION ONCE CUTTING OPERATION HAS BEGUN.

CHANGING DIRECTION CAN RESULT IN INJURY, THROWN MATERIAL, OR JAMMING OF THE

CUTTER HEAD.

h. MAKE SURE the cutters are sharp.

i. Bottom of shaper cutter must be set in alignment as is proper for that cutter. When changing

the cutter and after installation, the Shop Monitor, or a knowledgeable member of the shop,

must be called to check out the installation.

j. Shaper Speed is set at 9000 RPM. Do not attempt to make a change to rotation speed.

k. USE proper Eye Protection and a Dust Mask.

l. DO NOT WEAR TIE, GLOVES, or loose clothing. REMOVE WATCH, RINGS, and other jewelry.

ROLL UP SLEEVES.

m. NEVER TURN THE MACHINE “ON” before clearing the table of all objects (tools, scraps of wood,

etc.).

n. AVOID AWKWARD OPERATIONS AND HAND POSITIONS where a sudden slip could cause a hand

to move into the cutter.

o. NEVER START THE MACHINE with the workpiece contacting the cutter.

p. DO NOT FEED A WORKPIECE that is warped, contains loose knots, or is embedded with foreign

objects (nails, staples, etc.). Workpiece must be flat and square, with reference surface marked

in cases where two ends are intended to be cut.

q. PROVIDE SUFFICIENT BEARING SURFACE when shaping with a starting pin and collar(s).

r. ONLY SHAPE LARGE WORKPIECES when using starting pin and collar(s). DO NOT SHAPE short or

light workpieces when using starting pin and collar(s).

s. POSITION THE CUTTER below the collar(s) when shaping with starting pin and collar(s).

t. PROPERLY SUPPORT LONG OR WIDE WORKPIECES.

u. NEVER PERFORM LAYOUT, ASSEMBLY or setup work on the table/work area when the machine

is running.

1 2 ... 125 126 127 128 129 130 131 132 133 134 135 ... 138 139

Pas de commentaire

Ryobi DBJ50 Instructions d'exploitation Page 130