Ryobi DBJ50 Instructions d'exploitation télécharger pdf (Page 31)

Page 22 Power Equipment Usage Manual (Rev. 5/10)

6.3. Setup & Use – 16” LaGuna Planer

Surface plane the workpiece on a jointer until it is flat on one side. This will

ensure that it sits flat on the planer table during operation.

To obtain even, uniform thickness across the length of a board, the stock being planed must have one

face that has already been machined perfectly flat on the jointer and the stock must be fed with this flat

face against the table.

6.3.1. Adjusting the Depth of Cut

a. Cut capacity:

– WORKPIECE MUST BE 12” or longer

– Max. Width = 15-1/2”

– Min. Width = 2”

– Max. Thickness = 8”

b. To set the initial depth of cut:

• Raise the table until wood stock slightly touches the red

bar at the center located above the in-feed table.

• CAUTION: Maximum cutting depth is 1/16th"

c. Be sure to always lock the depth adjustment after changing it. The planer vibrates significantly

and the setting can change during a cut.

d. Often it is desirable to get the lightest cut possible on a given workpiece.

• To do so, set the depth setting so it is at least 1/8” more than the board at its thickest

point.

• Then, run a board and as you start it into the machine, lower the cut depth adjustment

until the board moves steadily and a light cut is heard. Now you know you are taking a

very minimum cut.

• Run the board a second time to take this cut on the entire board and you have it.

e. To take subsequent cuts, a 1/4 wheel revolution is a good cut.

f. To get an accurate cut on a wide board, do a test cut and measure the four corners of the board.

If there is a significant variation, maintenance should be done on the machine to level the feed

tables with the cutterhead.

6.3.2. Operating the Planer

a. To START/STOP the planer:

• Open the Dust Collection Vent.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 138 139

Pas de commentaire

Ryobi DBJ50 Instructions d'exploitation Page 31