Ryobi DBJ50 Instructions d'exploitation télécharger pdf (Page 52)

Page 43 Power Equipment Usage Manual (Rev. 5/10)

o As with any re-saw blade, the surface finish of the cut will not be completely

smooth. (NOTE: Adjust thickness to allow for finish sanding to final desired

thickness)

o The small Hand Wheel attached to and located at the back of the Screw Drive

Assembly will provide the proper adjustment for thickness of cut.

 The single Clamp Fence Locking Screw must be:

• Loosened prior to making any adjustment to the fence.

• Tightened when the adjustment has been completed.

• CAUTION: Clamp Locking Screws on this unit must not be over-

tightened!!

 Rotating the Hand Wheel counter-clockwise one full revolution will move

the fence and stock forward 1/16”. Two full revolutions will move the fence

and stock forward 1/8’.

 NOTE: Always rotate the disk one extra full rotation more than the desired

re-saw thickness to account for the 1/16’ kerf/cut of the blade.

8.4. Setup & Use – 20” Delta Band Saw (for Re-sawing)

Start by positioning the fence and double checking to make sure it is square (at 90

degrees). This is especially necessary for this saw.

a. Machine Setup: The 20” Delta 28-640/641 setup with a 1” blade for re-sawing of boards and

logs.

b. Primary Use is ‘re-sawing’:

• Cut thick boards down to thinner boards

• Make veneer from precious figured board.

• If you want thin stock for small boxes or drawers, it’s a lot cheaper to make your own than

to buy it.

• Get useful lumber from a log.

• Cut blanks for turning on the wood lathe.

When re-sawing boards, be sure to use a

PUSH BLOCK to keep your fingers well

away from the action!

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 138 139

Pas de commentaire

Ryobi DBJ50 Instructions d'exploitation Page 52