Ryobi DBJ50 Instructions d'exploitation télécharger pdf (Page 55)

Page 46 Power Equipment Usage Manual (Rev. 5/10)

b) Set the saw’s miter and bevel angles

c) Secure the stock firmly against the fence

d) Line up the mark with the laser line and the saw blade will cut to the right of the laser line

9.3. Setup & Use – Sliding Compound Miter Saw

10.2.1. Capacity & Angles

The sliding compound miter saw is operated the same as the compound miter saw, but has the ability to

accommodate larger boards:

Bevels 0° - 48° with positive stops at 0°, 22.5°, 33.9° and 45° in both directions.

Cuts up to 2x16” dimensional lumber at 90° and 2x12” at 45°.

Miters 60° to the left and 50° to the right.

9.3.1. Operation

For precision cuts, it is important to perform a test cut to identify the exact relationship of the marked

line to the finished cut. Once you know where the saw blade will cut, then you can accurately cut your

workpiece.

Mark the board for the cut.

Setting miter and bevel angles:

• Bevel angels can be set at 48 degrees right or left and can be cut with miter arm set

between 50 degrees right or 60 degrees left.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 138 139

Pas de commentaire

Ryobi DBJ50 Instructions d'exploitation Page 55