Ryobi TSS120L Manuel d'utilisation et d'entretien télécharger pdf (Page 14)

14 − English

Fig. 10

ASSEMBLY

MOUNTING HOLES

See Figure 8.

WARNING:

Before starting any cutting operation, clamp or bolt your

miter saw to a workbench or an approved miter saw stand.

If a miter saw stand is used, read operator’s manual and

follow the instructions for the miter saw stand. Never

operate your miter saw on the floor or in a crouched

position. Failure to heed this warning can result in serious

personal injury.

The compound miter saw should be mounted to a firm

supporting surface such as a workbench. Four bolt holes

have been provided in the saw base for this purpose. Each

of the four mounting holes should be bolted securely using

5/16 in. machine bolts, lock washers, and hex nuts (not

included). Bolts should be of sufficient length to accommodate

the saw base, lock washers, hex nuts, and the thickness of

the workbench. Tighten all four bolts securely.

The hole pattern for mounting to a workbench is shown in

figure 8. Carefully check the workbench after mounting to

make sure that no movement can occur during use. If any

tipping, sliding, or walking is noted, secure the workbench

to the floor before operating.

USING THE DEPTH STOP

See Figure 9.

When used, the depth stop limits the downward travel of

the blade when cutting dadoes and other non-through cuts.

To use the depth stop:

 Unplug the saw.

 If the saw is in storage or transport position, unlock the

saw arm.

 Rotate the depth stop away from the motor housing.

 With the end of the depth control knob touching the depth

stop, adjust the depth control knob by turning the knob

until the desired depth of cut is attained.

 A wooden spacer of at least 2 1/4 inches must be placed

between the workpiece and the fence for a consistent

depth of cut in the workpiece. Use the work clamp to

clamp the spacer and another suitable clamp to clamp

the workpiece. Make the slide cut at the desired depth.

See Figures 36 and 37.

 Rotate the depth stop back towards the motor housing

for normal through cuts.

NOTE: The depth stop must be moved toward the motor

housing before locking / unlocking the saw arm.

LOCKING / UNLOCKING THE SAW ARM

See Figure 10.

When locking and unlocking the saw arm, it is not necessary

to loosen the depth control knob.

LOCK

“D”

HANDLE

Fig. 9

To unlock and raise the saw arm:

 Firmly grasp the “D” handle and apply downward pressure

while at the same time pulling the lock pin out and away

from the saw housing.

 Release the lock pin and slowly raise the saw arm.

To lock the saw arm:

 Firmly grasp the “D” handle and apply downward pressure

while at the same time pushing the lock pin in and toward

the saw housing.

 Release the lock pin allowing it to lock the saw into place.

DEPTH

CONTROL KNOB

DEPTH STOP

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 103 104

Commentaires sur ces manuels

Pas de commentaire

Ryobi TSS120L Manuel d'utilisation et d'entretien Page 14

Commentaires sur ces manuels