Ryobi TSS120L Manuel d'utilisation et d'entretien télécharger pdf (Page 25)

25 − English

OPERATION

 Grasp the saw handle firmly. Squeeze the switch trigger.

Allow several seconds for the blade to reach maximum

speed.

 Slowly lower the blade into and through the workpiece.

 Release the switch trigger and allow the saw blade to

stop rotating before raising the blade out of workpiece

and removing the workpiece from the miter table.

TO BEVEL CUT

See Figure 32.

A bevel cut is made by cutting across the grain of the

workpiece with the blade angled to the workpiece. A straight

bevel cut is made with the miter table set at the zero degree

position and the blade set at an angle between 0° and 45°.

NOTE: It may be necessary to adjust or remove the sliding

miter fence to insure proper clearance prior to making the cut.

 Pull out the lock pin and lift saw arm to its full height.

 Loosen the miter lock handle approximately one-half turn

and squeeze the detent release lever.

 Rotate the control arm until the pointer aligns with the

desired angle on the miter scale.

 Release the detent release lever, then tighten the miter

lock knob to secure the miter table.

NOTE: You can quickly locate 0°, 15°, 22-1/2°, 31.6°,

and 45° left or right by releasing the detent release lever

as you rotate the control arm. The control arm will seat

itself in one of the positive stop notches, located in the

miter table base.

 Loosen the bevel lock knob and move the saw arm to

the desired bevel angle.

 Bevel angles can be set from 0° to 45°.

 Align the indicator point for the desired angle.

 Once the saw arm has been set at the desired angle,

securely tighten the bevel lock knob.

 Place the workpiece flat on the miter table with one edge

securely against the fence. If the board is warped, place

the convex side against the fence. If the concave edge

of a board is placed against the fence, the board could

collapse on the blade at the end of the cut, jamming the

blade. See Figures 42 - 43.

 When cutting long pieces of lumber or molding, support

the opposite end of the stock with a roller stand or with

a work surface level with the saw table. See Figure 35.

Fig. 32

WORK

CLAMP

BEVEL CUT

 Slide the saw head to its most rearward position and

tighten the slide lock knob securely.

 Align the cutting line on the workpiece with the edge of

saw blade or laser line.

 Grasp the stock firmly with one hand and secure it against

the fence. Use the work clamp, C-clamp, or other suitable

clamp to secure the workpiece when possible.

 Before turning on the saw, perform a dry run of the cutting

operation just to make sure that no problems will occur

when the cut is made.

 Grasp the saw handle firmly then squeeze the switch

trigger. Allow several seconds for the blade to reach

maximum speed.

 Slowly lower the blade into and through the workpiece.

 Release the switch trigger and allow the saw blade to stop

rotating before raising the blade out of workpiece. Wait

until the electric brake stops blade from turning before

removing the workpiece from miter table.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 103 104

Commentaires sur ces manuels

Pas de commentaire

Ryobi TSS120L Manuel d'utilisation et d'entretien Page 25

Commentaires sur ces manuels