Ryobi RT501W Spécifications télécharger pdf (Page 13)

ASSEMBLE THE MITER GUIDE

See Figure 11

15. Place the miter guide head (E) on top of the miter bar

(X). Now fasten together by screwing the self tapping

screw (AF) into the miter guide head. Assemble miter

guide by threading carriage bolt (AA) through miter bar

(X). Place washer (AE) and knob (S) on end of carriage

bolt. Tighten knob and then attach miter pointer (W) to

rear of miter bar (X) with self tapping screw (AF).

ASSEMBLY

TO ATTACH THE FEATHERBOARDS

See Figure 9

13. Insert the hex head screw (AJ) into the sliding block

(J). Place the sliding block into the slot of the feather-

board (H). Secure by placing washer (AE) over the hex

head screw (AJ). Screw together by turning the knob

(S) clockwise. NOTE: Do not completely tighten at this

stage. Repeat the above for the remaining 2 feather-

boards.

Fig. 9

WARNING:

Before mounting the router make sure you have read

and understood pages 10-13 of your owner’s manual.

Fig. 10

AJ (3)

See Figure 10

14. Position 2 of the featherboards on the fence and

secure by turning the knobs (S) clockwise. Place the

third featherboard into the slot provided on the table-

top and tighten in the same way.

AE (3)

Fig. 11

AA (1)

AE (1) AF (2)

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 27 28

Pas de commentaire

Ryobi RT501W Spécifications Page 13