Ryobi CS1800 Manuel de l'opérateur télécharger pdf (Page 14)

ASSEMBLY

Fig. 8

WARNING:

Always make sure the compound miter saw is securely

mounted to a workbench or an approved workstand. Failure

to heed this warning can result in serious personal injury.

MOUNTING THE MITER SAW BASE TO THE

STAND

See Figure 8.

If a stand was included with your miter saw, follow the in-

structions below to mount the saw base to the stand. If a

stand was not included and your saw came preassembled,

or if you prefer to mount to a workbench, proceed to the

next section, Mounting Holes, to mount the miter saw to

a workbench.

Place the miter saw base on the stand so that the base is

seated firmly on the stand and the holes in the bottom of

the base are aligned with the threaded shaft of the knobs

in the stand.

Tighten the knobs securely, but do not overtighten.

trace hoLes

at these Locations

for hoLe pattern

Fig. 9

Mounting

surface

base

trace hoLes

at these Locations

for hoLe pattern

MOUNTING HOLES

See Figure 9.

If not using a stand, the saw should be mounted to a firm

supporting surface such as a workbench. Four bolt holes

have been provided in the saw base for this purpose. Each

of the four mounting holes should be bolted securely using

1/4 in. machine bolts, lock washers, and hex nuts (not

included). Bolts should be of sufficient length to accommodate

the saw base, lock washers, hex nuts, and the thickness of

the workbench. Tighten all four bolts securely.

The hole pattern for mounting to a workbench is shown in

figure 9. Carefully check the workbench after mounting to

make sure that no movement can occur during use. If any

tipping, sliding, or walking is noted, secure the workbench

to the floor before operating.

saw base

stand

knobs

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

Ryobi CS1800 Manuel de l'opérateur Page 14

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à chaîne Ryobi CS1800