Ryobi P610 Manuel de l'opérateur Page 11

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 20
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 10
11
OPERATION
CHARGING A HOT BATTERY PACK
When using the tool continuously, the batteries in the battery
pack will become hot. You should let a hot battery pack cool
down for approximately 30 minutes before attempting to
recharge. When the battery pack becomes discharged and
is hot, this will cause the green LED to come on instead of
the red LED. After 30 minutes, reinsert the battery pack in
the charger. If the green LED continues to remain on, return
battery pack to your nearest Authorized Service Center for
checking or replacing.
NOTE: This situation only occurs when continuous use of the
tool causes the batteries to become hot. It does not occur
under normal circumstances. Refer to CHARGING A COOL
BATTERY PACK for normal recharging of batteries. If the
charger does not charge your battery pack under normal
circumstances, return both the battery pack and charger
to your nearest Authorized Service Center for electrical
check.
TO INSTALL BATTERY PACK
See Figure 5.
Place the lock-off button in the center position to lock
the switch.
Place the battery pack in the tool. Align raised rib on
battery pack with the groove inside the tool.
Slide the battery pack into the tool until the latches on
each side of the battery pack snap into place and battery
pack is secured in the tool before beginning operation.
CAUTION:
When placing battery pack in the tool, be sure raised rib
on battery pack aligns with the battery port of the planer
and latches into place properly. Improper installation
of the battery pack can cause damage to internal
components.
TO REMOVE BATTERY PACK
See Figure 5.
Place the lock-off button in the center position to lock
the switch.
Locate latches on side of battery pack and depress to
release battery pack from the tool.
The battery pack will automatically disconnect when
buttons are depressed.
Remove the battery pack from the tool.
BATTERY
PACK
LATCH
Fig. 4
BATTERY PACK SHOWN IN CHARGER
GREEN
LED
YELLOW
LED
RED LED
P110
CHARGER
P100
BATTERY PACK
Fig. 5
Vue de la page 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Commentaires sur ces manuels

Pas de commentaire