Ryobi 4060310 Manuel d'utilisateur télécharger pdf (Page 4)

TOOLS NEEDED

Fig. 3

INSTALLING THE MITER SLOT TABLE

See Figure 3.

■ Turn the ON/OFF switch to the OFF position.

■ Unplug the saw from the switched on-board outlet.

■ Disconnect the saw from the power supply.

■ Remove the sliding miter table and accessory table

from the saw.

■ Place the miter slot table onto the saw as shown in

Figure 3.

WARNING:

The table saw should never be connected to a power

supply while you are assembling parts. Disconnect-

ing the table saw will prevent accidental starting that

could cause serious personal injury.

ASSEMBLY

7/16 in. NUT DRIVER

Fig. 2

3/16 in. HEX KEY

1/4-20 x 1 in.

HEX CAP SCREW

WASHER

1/4-20 NUT

SHIMS

MITER

SLOT TABLE

1 2 3 4 5 6

Pas de commentaire

Ryobi 4060310 Manuel d'utilisateur Page 4