Ryobi CSB121 Manuel d'utilisateur télécharger pdf (Page 21)

WARNING:

When servicing use only identical Ryobi replacement parts. Use of any other parts may create a hazard or

cause product damage.

GENERAL

Avoid using solvents when cleaning plastic parts. Most

plastics are susceptible to damage from various types of

commercial solvents and may be damaged by their use.

Use clean cloths to remove dirt, carbon dust, etc.

WARNING:

Do not at any time let brake fluids, gasoline,

petroleum-based products, penetrating oils, etc.

come in contact with plastic parts. They contain

chemicals that can damage, weaken, or destroy

plastic.

When electric tools are used on fiberglass boats, sports

cars, wallboard, spackling compounds, or plaster, it has

been found that they are subject to accelerated wear and

possible premature failure, as the fiberglass chips and

grindings are highly abrasive to bearings, brushes,

commutators, etc. Consequently, it is not recommended

that this tool be used for extended work on any fiberglass

material, wallboard, spackling compounds, or plaster. If,

however, you do work with any of these materials, it is

extremely important that the tool is cleaned frequently by

blowing with an air jet.

WARNING:

Always wear safety goggles or safety glasses with

side shields during power tool operation or when

blowing dust. If operation is dusty, also wear a dust

mask.

MAINTENANCE

LUBRICATION

All of the bearings in this tool are lubricated with a

sufficient amount of high grade lubricant for the life of the

unit under normal operating conditions. Therefore, no

further lubrication is required.

1 2 ... 16 17 18 19 20 21 22

Pas de commentaire

Ryobi CSB121 Manuel d'utilisateur Page 21