Ryobi BID1821 Manuel d'utilisateur télécharger pdf (Page 6)

English

FR DE ES IT NL PT DK SE FI NO RU PL CZ HU RO LV LT EE HR SI SK GR TR

OPERATION

NOTE: You might hear a whistling or ringing noise from

the switch during use. Do not be concerned; this is a

normal part of the switch function.

DIRECTION OF ROTATION SELECTOR

(FORWARD/REVERSE/CENTER LOCK)

See Figure 3.

The direction of bit rotation is reversible and is controlled

by a selector located above the switch trigger. With the

drill held in normal operating position, the direction of

rotation selector should be positioned to the left of the

switch trigger for forward drilling. The drilling direction is

reversed when the selector is to the right of the switch

trigger.

Setting the switch trigger in the OFF (center lock) position

helps reduce the possibility of accidental starting when

not in use.

CAUTION:

To prevent gear damage, always allow the chuck

to come to a complete stop before changing the

direction of rotation.

To stop, release switch trigger and allow the coupler to

come to a complete stop..

BUILT-IN COUPLER

See Figure 4.

The tool has a built-in coupler. The coupler has been

designed to accept 6.35 mm hex bits.

INSTALLING BITS

See Figure 4.

 Lock switch trigger on the tool by placing the direction

of rotation selector in center position.

 Slide the coupler forward and hold in position.

 Insert bit straight into coupler.

 Slide the coupler back slowly and release.

REMOVING BITS

See Figure 4.

 Lock switch trigger or the drill by placing the direction

of rotation selector in center position.

 Slide the coupler forward and hold in position.

 Pull bit straight out of coupler.

WARNING

Make sure the bit is secured in the coupler

before using the impact driver. Failure to do so

could cause serious personal injury.

WARNING

Do not drive a screw where there is likely to

be hidden wiring behind the surface. Contact

with a “live” wire will make exposed metal parts

of the tool “live” and shock the operator. If you

must drive a screw where hidden wire may be

present, always hold tool by insulated gripping

surfaces (handle) when performing the operation

to prevent a shock to the operator, as seen in

figure 5.

CAUTION:

The impact driver is not designed to be used as

a drill.

DRIVING OR REMOVING SCREWS

See Figures 5 - 6.

 Place the direction of rotation selector in the correct

position for the operation.

 Hold the impact driver with one hand.

 Place the bit on the screw head and slowly depress

the switch trigger. Start the bit slowly for more control.

 As the screw is driven, impacting will begin.

MAINTENANCE

WARNING:

When servicing, use only identical Ryobi

replacement parts. Use of any other parts may

create a hazard or cause product damage.

WARNING:

Always wear safety goggles or safety glasses

with side shields during power product operation

or when blowing dust. If operation is dusty, also

wear a dust mask.

WARNING:

To avoid serious personal injury, always remove

the battery pack from the product when cleaning

or performing any maintenance.

Avoid using solvents when cleaning plastic parts. Most

plastics are susceptible to damage from various types of

commercial solvents and may be damaged by their use.

Use clean cloths to remove dirt, dust, oil, grease, etc.

1 2 3 4 5 6 7 8 9 10 11 ... 114 115

Commentaires sur ces manuels

Pas de commentaire

Ryobi BID1821 Manuel d'utilisateur Page 6

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Ryobi BID1821