Ryobi HG500 Manuel de l'opérateur télécharger pdf (Page 10)

10 11

Persons removing paint should follow these guidelines:

n Move the workpiece outdoors. If this is not possible, keep

the work area well ventilated. Open the windows and put

an exhaust fan in one of them. Be sure the fan is moving

the air from inside to outside.

n Remove or cover any carpets, rugs, furniture, clothing,

cooking utensils, and air ducts.

n Place drop cloths in the work area to catch any paint chips

or peelings. Wear protective clothing such as extra work

shirts, overalls, and hats.

n Work in one room at a time. Furnishings should be re-

moved or placed in the center of the room and covered.

Work areas should be sealed off from the rest of the

dwelling by sealing doorways with drop cloths.

n Children, pregnant or potentially pregnant women, and

nursing mothers should not be present in the work area

until the work is done and all clean up is complete.

n Wear a dust respirator mask or a dual filter (dust and

fume) respirator mask which has been approved by the

Occupational Safety and Health Administration (OSHA),

the National Institute of Safety and Health (NIOSH), or

the United States Bureau of Mines. These masks and

replaceable filters are readily available at major hardware

stores. Be sure the mask fits. Beards and facial hair may

keep masks from sealing properly. Change filters often.

DISPOSABLE PAPER MASKS ARE NOT ADEQUATE.

n Use caution when operating the heat gun. Keep the heat

gun moving as excessive heat will generate fumes

n Keep food and drink out of the work area. Wash hands,

arms and face and rinse mouth before eating or drink-

ing. Do not smoke or chew gum or tobacco in the work

area.

n Clean up all removed paint and dust by wet mopping the

floors. Use a wet cloth to clean all walls, sills, and any

other surface where paint or dust is clinging. DO NOT

SWEEP, DRY DUST, OR VACUUM. Use a high phosphate

detergent or trisodium phosphate (TSP) to wash and mop

areas.

n At the end of work session, put the paint chips and debris

in a double plastic bag, close it with tape or twist ties,

and dispose of properly.

n Remove protective clothing and work shoes in the work

area to avoid carrying dust into the rest of the dwelling.

Wash work clothes separately. Wipe shoes off with a wet

rag that is then washed with the work clothes. Wash hair

and body thoroughly with soap and water.

OPERATION

WARNING:

Do not allow familiarity with tools to make you careless.

Remember that a careless fraction of a second is suf-

ficient to inflict serious injury.

WARNING:

Always wear safety goggles or safety glasses with side

shields, a dust respirator mask or dual filter respirator

mask, and protective gloves when operating the heat gun.

Failure to do so could result in possible serious injury.

WARNING:

Do not use any attachments or accessories not recom-

mended by the manufacturer of this tool. The use of

attachments or accessories not recommended can result

in serious personal injury.

APPLICATIONS

You may use this tool for the purposes listed below:

n Soften paint, caulking and putty for easier removal

n Soften adhesives to help remove stickers, floor tiles,

wallpaper, etc.

n Heating plastic and metal for bending

n Soldering pipe joints

n Shrink tubing for electrical work

n Shrink plastic film for wrapping or weatherproofing

n Loosen rusted nuts, bolts, and fittings

READ THIS INSTRUCTION

WARNING:

Use extreme care when stripping paint. The peelings,

residue, and vapors of paint may contain lead, which

is poisonous. Any pre-1977 paint may contain lead and

paint applied to homes prior to 1950 is likely to contain

lead. Once deposited on surfaces, hand to mouth contact

can result in the ingestion of lead. Exposure to even low

levels of lead can cause irreversible brain and nervous

system damage; young and unborn children are par-

ticularly vulnerable. Before beginning any paint removal

process, you should determine whether the paint you are

removing contains lead. This can be done by your local

health department or by a professional who uses a paint

analyzer to check lead content of the paint to be removed.

LEAD-BASED PAINT SHOULD ONLY BE REMOVED BY

A PROFESSIONAL AND SHOULD NOT BE REMOVED

USING A HEAT GUN.

1 2 ... 5 6 7 8 9 10 11 12 13 14

Commentaires sur ces manuels

Pas de commentaire

Ryobi HG500 Manuel de l'opérateur Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Ryobi HG500