Ryobi RTS30 Manuel de l'opérateur télécharger pdf (Page 38)

ADJUSTMENTS

Fig. 48

Fig. 49

0° ADJUSTMENT

SCREW

45° ADJUSTMENT

SCREW

COMBINATION

SQUARE

BLADE

BEVEL

INDICATOR

BEVEL

LOCKING

LEVER

BEVEL

HANDLE

45°

COMBINATION

SQUARE

BLADE

BEVEL

HANDLE

BEVEL

INDICATOR

BEVEL

LOCKING

LEVER

TO SET THE BLADE AT 0° AND 45°

See Figures 47 - 49.

The angle settings of the saw have been set at the factory

and, unless damaged in shipping, should not require set-

ting during assembly. After extensive use, they may need

to be checked.

 Unplug the saw.

 Raise the blade.

If the blade is not perfectly vertical (0°):

 Loosen the adjustment screw and the bevel locking

lever.

 Place a combination square beside the blade on the left.

Lock the angle by pushing the bevel locking lever down

and retighten the adjustment screw.

 Turn the handle until the bevel indicator points to zero.

If the handle is turned as far as possible and doesn’t

indicate zero properly, you may need to adjust the bevel

indicator.

NOTE: It will be necessary to remove the handle to adjust

the bevel indicator.

If the blade is not an exact 45°:

 Loosen the adjustment screw and the bevel locking

lever.

 Place a combination square beside the blade on the

left.

 Turn the handle until the bottom of the blade has moved

completely to the left side of the slot. Lock the angle by

pushing the bevel locking lever.

 If the blade is not an exact 45°, loosen the 45° adjustment

screw and the bevel locking lever.

 Adjust the bevel indicator to 45°.

 Make a test cut.

0°

Fig. 47

1 2 ... 33 34 35 36 37 38 39 40 41 42

Commentaires sur ces manuels

Pas de commentaire

Ryobi RTS30 Manuel de l'opérateur Page 38

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Ryobi RTS30