Ryobi BGH615 Manuel d'utilisateur télécharger pdf (Page 15)

Page 15

CHISEL SHARPENING

CHISELS AND SCREWDRIVER BLADES

See Figure 10.

When sharpening chisels and screwdrivers, work rest

should support the chisel at the correct angle against the

wheel.

WARNING:

Always disconnect the bench grinder from the power

source before performing any assembly or adjustment.

Failure to do so could result in accidental starting result-

ing in possible serious personal injury.

WHEEL REPLACEMENT

See Figure 11.

If you must replace a grinding wheel, be sure to obtain one

with a safe rated speed at least as high as the “no load

speed” RPM marked on the data plate of the grinder and

which is marked to comply with ANSI B7.1.

To replace the grinding wheel, remove the wheel cover by

loosening the screws. Loosen the wheel nut in a clockwise

direction for the left side and a counterclockwise direction

for the right side. Remove the outer flange and grinding

wheel. To install a new grinding wheel, reverse the above

procedure. Be sure the grinding wheel and outer flange are

properly seated on the spindle shaft.

OPERATION

Fig. 10

Fig. 11

SCREW(S)

GRINDING

WHEEL

OUTER

FLANGE

INNER

FLANGE

STAR

WASHER(S)

HEX NUT(S)

WHEEL

GUARD COVER

WHEEL

NUT

SPINDLE

SHAFT

1 2 ... 10 11 12 13 14 15 16 17 18

Commentaires sur ces manuels

Pas de commentaire

Ryobi BGH615 Manuel d'utilisateur Page 15

Commentaires sur ces manuels

Produits connexes et manuels pour Outils Ryobi BGH615