Ryobi 130rEB Manuel de l'opérateur télécharger pdf (Page 15)

MAINTENANCE AND REPAIR INSTRUCTIONS

Fig. 23

Fig. 24

Fig. 22

Fig. 25

9. Place the spring in the inner reel. Insert the ends of

the line through the eyelets in the outer spool and

place inner reel inside the outer spool (Fig. 25). Push

the inner reel and outer spool together. While holding

the inner reel and outer spool, grasp the ends and

pull firmly to release the line from the holding slots in

the spool.

NOTE: The spring must be assembled on the inner reel

before reassembling the cutting attachment.

7. Wind the lines in tight even layers, onto the reel

(Fig. 23). Wind the line in the direction indicated on

the inner reel. Place your index finger between the

two lines to stop the lines from overlapping. Do not

overlap the ends of the line.

NOTE: Failure to wind the line in the direction indicated

will cause the cutting attachment to operate

incorrectly.

8. Insert the ends of the line into the two holding slots

(Fig. 24).

Holding Slots

10. Hold the inner reel in place and install the Bump

Knob by turning clockwise. Tighten securely.

INSTALLING A PREWOUND REEL

1. Hold the outer spool with one hand and unscrew the

Bump Knob counterclockwise (Fig. 18). Inspect the

bolt inside the Bump Knob to make sure it moves

freely. Replace the Bump Knob if damaged.

2. Remove the old inner reel from the outer spool

(Fig. 19).

3. Remove the spring from the old inner reel (Fig. 19).

4. Use a clean cloth to clean the spring, shaft, and

inner surface of the outer spool (Fig. 20).

5. Place the spring in the new inner reel. Insert the ends

of the line through the eyelets in the outer spool

(Fig. 25).

6. Place the new inner reel inside the outer spool. Push

the inner reel and outer spool together. While holding

the inner reel and outer spool, grasp the ends and

pull firmly to release the line from the holding slots in

the spool.

NOTE: The spring must be assembled on the inner reel

before reassembling the cutting attachment.

7. Hold the inner reel in place and install the Bump

Knob by turning clockwise. Tighten securely.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20

Commentaires sur ces manuels

Pas de commentaire

Ryobi 130rEB Manuel de l'opérateur Page 15

Commentaires sur ces manuels

Produits connexes et manuels pour Tondeuses à gazon Ryobi 130rEB