Ryobi 130rEB Manuel de l'opérateur télécharger pdf (Page 8)

ASSEMBLY INSTRUCTIONS

Fig. 3

Fig. 4

INSTALLING CUTTING ATTACHMENT SHIELD

WARNING: To avoid injury, never operate the

trimmer without the cutting attachment shield

installed. If the trimmer is operated without it

in place, you will VOID the warranty.

1. Place the cutting attachment shield onto the shaft

housing above the clamp assembly (Fig. 3).

2. Push the cutting attachment shield down to the top

of the cutting attachment assembly and then rotate

the cutting attachment shield 180°. Align the 4 screw

holes and fit the cutting attachment shield securely

in the recessed pocket (Fig. 3).

3. Install the four (4) screws (10-24 x 1/2) with a regular

Phillips screwdriver (Fig. 4). Tighten securely.

Screws

Cutting

Attachment

Shield

Cutting

Attachment

Clamp

Assembly

Shaft Housing

Fig. 1

Fig. 2

D Handle

Wing Nut

ADJUSTING THE D-HANDLE

1. Hold the unit in the operating position (Fig. 1).

2. Loosen the wing nut (Fig. 2). It is not necessary to

remove the wing nut, washer or bolt.

3. Position the D-handle to the location that provides

you the best grip, and tighten the wing nut (Fig. 2).

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Pas de commentaire

Ryobi 130rEB Manuel de l'opérateur Page 8