Ryobi 130rEB Manuel de l'opérateur télécharger pdf (Page 16)

MAINTENANCE AND REPAIR INSTRUCTIONS

EDGER BLADE REPLACEMENT

WARNING:

To avoid serious personal injury,

always wear gloves while handling, removing

or installing the blade.

WARNING: The gear housing gets hot

after long periods of use. To avoid serious

personal injury, do not touch the housing

until it has cooled.

1. Line up the hole in output shaft with the locking rod

slot. Insert the locking rod through the slot into the

output shaft hole (Fig. 26).

2. While holding the locking rod, loosen the nut on the

blade by turning it clockwise with a 5/8 inch wrench

(Fig. 27). Remove the nut, retaining washer and

blade. Keep the nut and blade retainer for

installation.

3. Install the new blade, blade retainer, and nut

(Fig. 28). Insert the locking rod through the slot into

the output shaft hole. Make sure that the blade stays

flat and centered against the output shaft while

tightening the lock nut counterclockwise (Fig. 29).

Fig. 26

Fig. 28

Fig. 27

Fig. 29

4. If you have a torque wrench, tighten the nut to

325-335 in.•lbs (37-38 N•m), while holding the

locking rod in the slot.

If you do not have a torque wrench, hold the locking

rod in the slot. Rotate the nut counterclockwise

with a 5/8 inch closed-ended or socket wrench, until

the nut presses against the washer and the blade is

snug. Make sure the blade assembly is installed

correctly, then rotate the nut an additional 1/4-1/2

turn (Fig. 29).

5. Remove the locking rod.

WARNING: Verify the blade is flat against

the output shaft after the nut is tightened. If

the blade is off-center, the unit will be

damaged by vibration, and the blade may fly

off, which can cause serious personal injury.

Locking Rod

Blade Retainer

Lock Nut

Loosen

Tighten

Edger Blade

Output Shaft

Hole

Locking Rod

Slot

Output Shaft

ACCESSORIES/REPLACEMENT PARTS

Replacement Line . . . . . . . . . . . . . . . . . . . . . . . 610375

Replacement Line Cartridge . . . . . . . . . . . . . . . . 153577

Inner Reel Spring . . . . . . . . . . . . . . . . . . . . . . . . 610317

Bump Head Knob Assembly . . . . . . . . . . . . . . . . 153066

Edger Blade . . . . . . . . . . . . . . . . . . . . . . . . . . . . 613223

Blade Retaining Kit (edger blade) . . . . . . . . . . . . 180015

Locking Rod Tool . . . . . . . . . . . . . . . . . . . . . . . . 613226

Shoulder Strap . . . . . . . . . . . . . . . . . . . . . . . . . . 682075

1 2 ... 11 12 13 14 15 16 17 18 19 20

Commentaires sur ces manuels

Pas de commentaire

Ryobi 130rEB Manuel de l'opérateur Page 16

Commentaires sur ces manuels

Produits connexes et manuels pour Tondeuses à gazon Ryobi 130rEB