Ryobi BD4601 Manuel de l'opérateur télécharger pdf (Page 9)

9 - English

ASSEMBLY

MOUNTING THE WORK TABLE FOR USE WITH

THE DISC SANDER

See Figure 6, page 15.

 Insert the work table index pin into the hole in the tool’s

housing.

 Position a washer over the table lock knob then tighten

the table lock knob securely.

MOUNTING THE WORK TABLE FOR USE WITH

THE BELT SANDER

See Figure 7, page 15.

 Insert the work table index pin into the hole in the sanding

belt arm.

 Position a washer over the table lock knob then tighten

the table lock knob securely.

ASSEMBLING WORK SUPPORT

See Figure 8, page 15.

 Place the work support over the holes in the side of the

sanding belt arm.

 Using a hex key, fasten in place with washers and socket

head screws.

MOUNTING BELT/DISC SANDER TO WORK-

BENCH

See Figure 9, page 15.

If the belt/disc sander is to be used in a permanent location,

it is recommended you secure it to a workbench or other

stable surface. When mounting the belt/disc sander to a

workbench, holes should be drilled through the supporting

surface of the workbench.

 Mark holes on workbench where belt/disc sander is to be

mounted using holes in the base as a template for hole

pattern.

 Drill holes through workbench.

 Place belt/disc sander on workbench aligning holes in

the base with holes drilled in the workbench.

 Insert bolts (not included) and tighten securely with lock

washers and hex nuts (not included).

CLAMPING BELT/DISC SANDER TO WORK-

BENCH

See Figure 10, page 15.

If the belt/disc sander is to be used as a portable tool, it

is recommended you fasten it permanently to a mounting

board that can easily be clamped to a workbench or other

stable surface. The mounting board should be of sufficient

size to avoid tipping while belt/disc sander is in use. Any

good grade plywood or chipboard with a 3/4 in. thickness

is recommended.

 Mark holes on board where belt/disc sander is to be

mounted using holes in the base as a template for hole

pattern.

 Follow the last three steps in section Mounting Belt/Disc

Sander to Workbench.

If lag bolts are used, make sure they are long enough to

go through holes in belt/disc sander base and material the

belt/disc sander is being mounted to. If machine bolts are

used, make sure bolts are long enough to go through holes

in belt/disc sander, the material being mounted to, and the

lock washers and hex nuts.

WARNING:

Do not allow familiarity with tools to make you care-

less. Remember that a careless fraction of a second is

sufficient to inflict serious injury.

WARNING:

Always wear eye protection with side shields marked to

comply with ANSI Z87.1. Failure to do so could result in

objects being thrown into your eyes, resulting in possible

serious injury.

WARNING:

Do not use any attachments or accessories not

recommended by the manufacturer of this tool. The use

of attachments or accessories not recommended can

result in serious personal injury.

APPLICATIONS

This product has been designed only for the purposes listed

below:

Sanding and finishing plastic, wood, and wood composi-

tion materials

Bevel sanding

Horizontal and vertical sanding

Sanding curved pieces

OPERATION

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 43 44

Commentaires sur ces manuels

Pas de commentaire

Ryobi BD4601 Manuel de l'opérateur Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Ryobi BD4601