Ryobi DP103L Manuel d'utilisation et d'entretien télécharger pdf (Page 11)

11 - English

INSTALLING CHUCK, HEAD ASSEMBLY, AND

FEED HANDLES

See Figures 10 - 11, page 20.

Place the head assembly upside down on a level, flat

surface.

Position chuck on spindle. Chuck should be fully opened

to avoid damaging jaws.

Using a piece of scrap wood to protect the chuck, firmly

tap the chuck into place using a mallet or hammer.

Position the head assembly onto the column with the

chuck positioned over the table.

NOTE: This head assembly is heavy. Get help when

needed.

Slide the head assembly down as far as it will go. Align

the table assembly with the base and then tighten the

two head set screws with the hex key.

Attach the three feed handles by screwing them into the

threaded holes in the hub.

WARNING:

Use of controls or adjustments or performance of

procedures other than those specified herein could result

in hazardous radiation exposure.

MOUNTING THE DRILL PRESS

See Figure 12, page 20.

If the drill press is to be used in a permanent location, secure

it to a workbench or other stable surface.

If the drill press is to be used as a portable tool, fasten it

permanently to a mounting board that can easily be clamped

to a workbench or other stable surface. The mounting board

should be of sufficient size to avoid tipping while drill press

is in use. Any good grade plywood or chipboard with a

3/4 in. thickness is recommended.

Mark holes on surface where drill press is to be mounted

using holes in drill press base as a template for hole pat-

tern.

Drill holes through mounting surface.

Place drill press on mounting surface, aligning holes in

the base with holes drilled in the mounting surface.

Insert bolts (not included) and tighten securely with lock

washers and hex nuts (not included).

 If lag bolts are used, make sure they are long enough to

go through holes in drill press base and material the drill

press is being mounted to. If machine bolts are used,

make sure bolts are long enough to go through holes in

drill press, the material being mounted to, and the lock

washers and hex nuts.

NOTE: All bolts should be inserted from the top. Install

the lock washers and hex nuts from the underside of the

workbench.

Once the drill press is securely mounted on a sturdy surface:

Check for vibration when the motor is switched ON.



Adjust and retighten the mounting hardware as necessary.

Check the table assembly to assure smooth movement

up and down the column.



Check to assure that the spindle shaft moves smoothly.

CHECKING/ADJUSTING LASER ALIGNMENT

See Figure 13, page 20.

Check the laser alignment to ensure the intersection of the

laser lines is precisely at the spot where the drill bit meets

the workpiece. If it is not, the laser lines should be adjusted

using the laser adjustment knobs located on opposite sides

of the head assembly.

Mark an “X” on a piece of scrap wood.

Insert a small drill bit into the chuck and align its tip to

the intersection of the lines of the “X”.

Secure the board to the table.

Turn on the laser and verify the laser lines align with the

“X” on the workpiece.

If the laser lines do not align, loosen the set screws on

each of the laser housings with a hex key and rotate the

laser adjustment knobs until the lines meet in the center

of the “X”. Retighten the set screws to secure.

ASSEMBLY

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 55 56

Commentaires sur ces manuels

Pas de commentaire

Ryobi DP103L Manuel d'utilisation et d'entretien Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Ryobi DP103L