Ryobi DP103L Manuel d'utilisation et d'entretien télécharger pdf (Page 16)

16 - English

TROUBLESHOOTING

Problem Possible Cause Solution

Noisy operation Incorrect belt tension.

Dry spindle.

Loose spindle pulley or motor pulley.

Adjust belt tension.

Lubricate spindle.

Tighten set screws in pulleys.

Bit burns or smokes Incorrect speed.

Chips not coming out of hole

Dull bit.

Feeding too slow.

Not lubricated.

Change speed. See “Changing

Speeds” in the Adjustments section.

Retract bit frequently to clear chips

Sharpen or replace bit.

Feed fast enough; allow drill to cut.

Lubricate bit for metal work.

Excessive drill runout or wobble Bent bit.

Bit not properly installed in chuck.

Chuck not properly installed.

Worn spindle bearings.

Replace bit.

Install bit properly.

Install chuck properly.

Contact authorized service center.

Drill bit binds in workpiece Excessive feed pressure.

Improper belt tension.

Reduce feed pressure.

Adjust belt tension.

Workpiece support loosens Workpiece not supported or clamped

properly.

Check support and/or reclamp

workpiece.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 55 56

Pas de commentaire

Ryobi DP103L Manuel d'utilisation et d'entretien Page 16